[Buildroot] Buildroot on Toradex Colibri PXA300

[Buildroot] Buildroot on Toradex Colibri PXA300

[Marcus Tangermann]

Hello,

I try to build a system for a Colibri Board with the Iris carrier board from Toradex. Its a Marvell PXA300 with 64MB RAM and NAND flash.
I've configured a generic ARM for the toolchain and selected the colibri_pxa300_defconfig for the kernel which is already part of the Vanilla kernel.
When booting the kernel stops after uboot unpacked the kernel.

Has someone used this board before or has any hint?

Marcus

[Buildroot] Buildroot on Toradex Colibri PXA300

[Thomas Petazzoni]

Dear Marcus Tangermann,

On Wed, 10 Apr 2013 20:09:34 +0200, Marcus Tangermann wrote:

> I try to build a system for a Colibri Board with the Iris carrier
> board from Toradex. Its a Marvell PXA300 with 64MB RAM and NAND
> flash. I've configured a generic ARM for the toolchain and selected
> the colibri_pxa300_defconfig for the kernel which is already part of
> the Vanilla kernel. When booting the kernel stops after uboot
> unpacked the kernel.
> 
> Has someone used this board before or has any hint?

Enable CONFIG_DEBUG_LL, CONFIG_EARLYPRINTK and pass 'earlyprintk' on
your kernel command line. That should enable some more low-level
debugging messages.

I have personally never used PXA300 platforms, so I don't really know
at this point, but if we get more messages, it may provide some more
hints.

Best regards,

Thomas
-- 
Thomas Petazzoni, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com