Intel-GFX Archive on lore.kernel.org
 help / color / mirror / Atom feed
From: "Nautiyal, Ankit K" <ankit.k.nautiyal@intel.com>
To: "Ville Syrjälä" <ville.syrjala@linux.intel.com>
Cc: <intel-gfx@lists.freedesktop.org>, <jani.nikula@linux.intel.com>,
	<mitulkumar.ajitkumar.golani@intel.com>
Subject: Re: [PATCH 03/13] drm/i915/display: Add member fixed_rr to denote Fixed refresh rate with VRRTG
Date: Wed, 4 Sep 2024 18:24:00 +0530	[thread overview]
Message-ID: <90d259f9-bef3-4e79-a686-5c51b5b61ca2@intel.com> (raw)
In-Reply-To: <ZtcGZvU82Faddfrc@intel.com>


On 9/3/2024 6:21 PM, Ville Syrjälä wrote:
> On Mon, Sep 02, 2024 at 01:36:24PM +0530, Ankit Nautiyal wrote:
>> Add fixed_rr member to struct vrr to represent the case where a
>> fixed refresh rate with VRR timing generator is required.
>>
>> v2: Move get_config change where vrr.fixed is actually set. (Mitul)
>>
>> Signed-off-by: Ankit Nautiyal <ankit.k.nautiyal@intel.com>
>> ---
>>   drivers/gpu/drm/i915/display/intel_display.c       | 4 +++-
>>   drivers/gpu/drm/i915/display/intel_display_types.h | 2 +-
>>   2 files changed, 4 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/gpu/drm/i915/display/intel_display.c b/drivers/gpu/drm/i915/display/intel_display.c
>> index 78ce402a5cd0..8b437e79c8df 100644
>> --- a/drivers/gpu/drm/i915/display/intel_display.c
>> +++ b/drivers/gpu/drm/i915/display/intel_display.c
>> @@ -1005,7 +1005,8 @@ static bool vrr_params_changed(const struct intel_crtc_state *old_crtc_state,
>>   		old_crtc_state->vrr.vmin != new_crtc_state->vrr.vmin ||
>>   		old_crtc_state->vrr.vmax != new_crtc_state->vrr.vmax ||
>>   		old_crtc_state->vrr.guardband != new_crtc_state->vrr.guardband ||
>> -		old_crtc_state->vrr.pipeline_full != new_crtc_state->vrr.pipeline_full;
>> +		old_crtc_state->vrr.pipeline_full != new_crtc_state->vrr.pipeline_full ||
>> +		old_crtc_state->vrr.fixed_rr != new_crtc_state->vrr.fixed_rr;
> I have a feeling we shouldn't need this. We could just check for
> vmin==vmax instead.

I too was thinking the same but then we have cmrr also where vmin==vmax 
is there, along with cmrr specific stuff.


Regards,

Ankit

>
>>   }
>>   
>>   static bool cmrr_params_changed(const struct intel_crtc_state *old_crtc_state,
>> @@ -5480,6 +5481,7 @@ intel_pipe_config_compare(const struct intel_crtc_state *current_config,
>>   
>>   	if (!fastset) {
>>   		PIPE_CONF_CHECK_BOOL(vrr.enable);
>> +		PIPE_CONF_CHECK_BOOL(vrr.fixed_rr);
>>   		PIPE_CONF_CHECK_I(vrr.vmin);
>>   		PIPE_CONF_CHECK_I(vrr.vmax);
>>   		PIPE_CONF_CHECK_I(vrr.flipline);
>> diff --git a/drivers/gpu/drm/i915/display/intel_display_types.h b/drivers/gpu/drm/i915/display/intel_display_types.h
>> index 868ff8976ed9..62a796f61d20 100644
>> --- a/drivers/gpu/drm/i915/display/intel_display_types.h
>> +++ b/drivers/gpu/drm/i915/display/intel_display_types.h
>> @@ -1407,7 +1407,7 @@ struct intel_crtc_state {
>>   
>>   	/* Variable Refresh Rate state */
>>   	struct {
>> -		bool enable, in_range;
>> +		bool enable, in_range, fixed_rr;
>>   		u8 pipeline_full;
>>   		u16 flipline, vmin, vmax, guardband;
>>   		u32 vsync_end, vsync_start;
>> -- 
>> 2.45.2

  reply	other threads:[~2024-09-04 12:54 UTC|newest]

Thread overview: 29+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2024-09-02  8:06 [PATCH 00/13] Use VRR timing generator for fixed refresh rate modes Ankit Nautiyal
2024-09-02  8:06 ` [PATCH 01/13] drm/i915/dp: Avoid vrr compute config for HDMI sink Ankit Nautiyal
2024-09-02  8:06 ` [PATCH 02/13] drm/i915/dp: fix the Adaptive sync Operation mode for SDP Ankit Nautiyal
2024-09-02  8:06 ` [PATCH 03/13] drm/i915/display: Add member fixed_rr to denote Fixed refresh rate with VRRTG Ankit Nautiyal
2024-09-03 12:51   ` Ville Syrjälä
2024-09-04 12:54     ` Nautiyal, Ankit K [this message]
2024-09-02  8:06 ` [PATCH 04/13] drm/i915/display: Enable MSA Ignore Timing PAR only when in not fixed_rr mode Ankit Nautiyal
2024-09-03  3:15   ` kernel test robot
2024-09-03  7:52   ` kernel test robot
2024-09-02  8:06 ` [PATCH 05/13] drm/i915/dp: Set FAVT mode in DP SDP with fixed refresh rate Ankit Nautiyal
2024-09-02  8:06 ` [PATCH 06/13] drm/i915/vrr: Compute vrr vsync if platforms support it Ankit Nautiyal
2024-09-03 12:45   ` Ville Syrjälä
2024-09-04 12:55     ` Nautiyal, Ankit K
2024-09-02  8:06 ` [PATCH 07/13] drm/i915/hdmi: Use VRR Timing generator for HDMI Ankit Nautiyal
2024-09-02  8:06 ` [PATCH 08/13] drm/i915/display: Disable PSR before disabling VRR Ankit Nautiyal
2024-09-02  8:06 ` [PATCH 09/13] drm/i915/psr: Allow PSR for fixed refrsh rate with VRR TG Ankit Nautiyal
2024-09-02  8:06 ` [PATCH 10/13] drm/i915/vrr: Avoid sending PUSH when VRR TG is used with Fixed refresh rate Ankit Nautiyal
2024-09-03 13:02   ` Ville Syrjälä
2024-09-04 12:57     ` Nautiyal, Ankit K
2024-09-02  8:06 ` [PATCH 11/13] drm/i915/vrr: Handle joiner with vrr Ankit Nautiyal
2024-09-03 13:04   ` Ville Syrjälä
2024-09-04 13:02     ` Nautiyal, Ankit K
2024-09-02  8:06 ` [PATCH 12/13] drm/i915/vrr: Always use VRR timing generator for XELPD+ Ankit Nautiyal
2024-09-03 13:25   ` Ville Syrjälä
2024-09-04 13:08     ` Nautiyal, Ankit K
2024-09-02  8:06 ` [PATCH 13/13] drm/i915/display: Add fixed_rr to crtc_state_dump Ankit Nautiyal
2024-09-02 12:23 ` ✗ Fi.CI.SPARSE: warning for Use VRR timing generator for fixed refresh rate modes (rev5) Patchwork
2024-09-02 12:43 ` ✓ Fi.CI.BAT: success " Patchwork
2024-09-02 18:08 ` ✗ Fi.CI.IGT: failure " Patchwork

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=90d259f9-bef3-4e79-a686-5c51b5b61ca2@intel.com \
    --to=ankit.k.nautiyal@intel.com \
    --cc=intel-gfx@lists.freedesktop.org \
    --cc=jani.nikula@linux.intel.com \
    --cc=mitulkumar.ajitkumar.golani@intel.com \
    --cc=ville.syrjala@linux.intel.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox