From: plagnioj@jcrosoft.com (Jean-Christophe PLAGNIOL-VILLARD)
To: linux-arm-kernel@lists.infradead.org
Subject: [v4 PATCH 00/12] atmel spi controller with dmaengine and device tree support
Date: Tue, 5 Feb 2013 21:06:49 +0100 [thread overview]
Message-ID: <20130205200649.GD30595@game.jcrosoft.org> (raw)
In-Reply-To: <20130205141410.712493E1265@localhost>
On 14:14 Tue 05 Feb , Grant Likely wrote:
> On Mon, 14 Jan 2013 15:34:25 +0800, Wenyou Yang <wenyou.yang@atmel.com> wrote:
> > Hi All,
> >
> > This set of patches is to add dmaengine and device tree support for atmel spi.
> > The work is based on Nicolas and Richard's work.
> > It is tested on at91sam9x5ek, at91sam9m10g45ek, at91sam9263ek and at91sam9g20ek.
> >
> > It is based on v3.8-rc3.
>
> Hi Wenyou,
>
> The patches look fine on a quick look, but I cannot apply them without a
> Signed-off-by line from you since you are the person posting the
> patches. Please read section 12 of Documentation/SubmittingPatches
> (about line #288) and then reply confirming what your signed-off-by line
> should be.
grant if it's ok with you I prefer this go via arm-soc
Best Regards,
J.
>
> >
> > Changelog:
> > v4:
> > 1./ Take Joe Perches's advance, rewrite atmel_spi_is_v2(struct atmel_spi *as)
> > and atmel_spi_use_dma(struct atmel_spi *as),
> > and remove atmel_spi_use_pdc(struct atmel_spi *as).
> >
> > 2./ Rebase on v3.8-rc3.
> >
> > V3:
> > 1./ Rebase on v3.8-rc2.
> >
> > 2./ Remove some Jean-Christophe's patches which has been
> > applied on v3.8-rc2.
> >
> > 3./ Remove spi property "cs-gpios" from the SoC dtsi files
> > to the board dts files to avoid some useless pin conflicts.
> >
> > v2:
> > 1./ Remove the patch :PATCH]mtd: m25p80: change the m25p80_read to reading page to page
> > which purpose to fix the BUG: when run "flashcp /bin/busybox /dev/mtdX" in
> > the at91sam9g25ek with DMA mode, it arises a OOPS.
> > Now fix it in this patch:
> > [PATHC] spi/atmel_spi: add dmaengine support changing to fix the [BUG].
> >
> > 2./ Remove two patches:
> > which purpose to read dts property to select SPI IP version and DMA mode
> > Now they will be gat from device tree different compatile.
> >
> > 3./ Fix DMA: when enable both spi0 AND spi1, the spi0 doesn't work BUG.
> >
> > 4./ Rebase v3.7-rc8.
> >
> > Best Regards,
> > Wenyou Yang.
> >
> > Nicolas Ferre (5):
> > spi/atmel_spi: add physical base address
> > spi/atmel_spi: call unmapping on transfers buffers
> > spi/atmel_spi: status information passed through controller data
> > spi/atmel_spi: add flag to controller data for lock operations
> > spi/atmel_spi: add dmaengine support
> >
> > Richard Genoud (6):
> > spi/atmel_spi: fix spi-atmel driver to adapt to slave_config changes
> > spi/atmel_spi: correct 16 bits transfers using PIO
> > spi/atmel_spi: correct 16 bits transfer with DMA
> > ARM: at91: add clocks for spi dt entries
> > ARM: dts: add spi nodes for atmel SoC
> > ARM: dts: add spi nodes for the atmel boards
> >
> > Wenyou Yang (1):
> > spi/atmel_spi: update the dt support
> >
> > arch/arm/boot/dts/at91sam9260.dtsi | 18 +
> > arch/arm/boot/dts/at91sam9263.dtsi | 18 +
> > arch/arm/boot/dts/at91sam9263ek.dts | 14 +
> > arch/arm/boot/dts/at91sam9g20ek_common.dtsi | 14 +
> > arch/arm/boot/dts/at91sam9g45.dtsi | 18 +
> > arch/arm/boot/dts/at91sam9m10g45ek.dts | 14 +
> > arch/arm/boot/dts/at91sam9n12.dtsi | 18 +
> > arch/arm/boot/dts/at91sam9n12ek.dts | 14 +
> > arch/arm/boot/dts/at91sam9x5.dtsi | 18 +
> > arch/arm/boot/dts/at91sam9x5ek.dtsi | 14 +
> > arch/arm/mach-at91/at91sam9260.c | 2 +
> > arch/arm/mach-at91/at91sam9g45.c | 2 +
> > arch/arm/mach-at91/at91sam9n12.c | 2 +
> > arch/arm/mach-at91/at91sam9x5.c | 2 +
> > drivers/spi/spi-atmel.c | 809 ++++++++++++++++++++++++---
> > 15 files changed, 908 insertions(+), 69 deletions(-)
> >
> > --
> > 1.7.9.5
> >
> >
> > _______________________________________________
> > linux-arm-kernel mailing list
> > linux-arm-kernel at lists.infradead.org
> > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
>
> --
> Grant Likely, B.Sc, P.Eng.
> Secret Lab Technologies, Ltd.
next prev parent reply other threads:[~2013-02-05 20:06 UTC|newest]
Thread overview: 29+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-01-14 7:34 [v4 PATCH 00/12] atmel spi controller with dmaengine and device tree support Wenyou Yang
2013-01-14 7:34 ` [v4 PATCH 01/12] spi/atmel_spi: add physical base address Wenyou Yang
2013-01-14 7:34 ` [v4 PATCH 02/12] spi/atmel_spi: call unmapping on transfers buffers Wenyou Yang
2013-01-14 7:34 ` [v4 PATCH 03/12] spi/atmel_spi: status information passed through controller data Wenyou Yang
2013-01-14 7:34 ` [v4 PATCH 04/12] spi/atmel_spi: add flag to controller data for lock operations Wenyou Yang
2013-01-14 7:34 ` [v4 PATCH 05/12] spi/atmel_spi: update the dt support Wenyou Yang
2013-02-05 20:04 ` Jean-Christophe PLAGNIOL-VILLARD
2013-02-06 1:19 ` Yang, Wenyou
2013-01-14 7:34 ` [v4 PATCH 06/12] spi/atmel_spi: add dmaengine support Wenyou Yang
2013-01-23 16:25 ` Richard Genoud
2013-01-24 0:44 ` Yang, Wenyou
2013-01-14 7:34 ` [v4 PATCH 07/12] spi/atmel_spi: fix spi-atmel driver to adapt to slave_config changes Wenyou Yang
2013-01-14 7:34 ` [v4 PATCH 08/12] spi/atmel_spi: correct 16 bits transfers using PIO Wenyou Yang
2013-01-14 7:34 ` [v4 PATCH 09/12] spi/atmel_spi: correct 16 bits transfer with DMA Wenyou Yang
2013-01-14 7:34 ` [v4 PATCH 10/12] ARM: at91: add clocks for spi dt entries Wenyou Yang
2013-01-14 7:34 ` [v4 PATCH 11/12] ARM: dts: add spi nodes for atmel SoC Wenyou Yang
2013-02-05 19:51 ` Jean-Christophe PLAGNIOL-VILLARD
2013-02-06 1:35 ` Yang, Wenyou
2013-02-06 9:40 ` Nicolas Ferre
2013-01-14 7:34 ` [v4 PATCH 12/12] ARM: dts: add spi nodes for the atmel boards Wenyou Yang
2013-02-05 19:50 ` Jean-Christophe PLAGNIOL-VILLARD
2013-02-06 1:34 ` Yang, Wenyou
2013-02-08 1:51 ` Yang, Wenyou
2013-02-08 16:55 ` Jean-Christophe PLAGNIOL-VILLARD
2013-01-18 8:46 ` [v4 PATCH 00/12] atmel spi controller with dmaengine and device tree support Richard Genoud
2013-01-18 9:31 ` Yang, Wenyou
2013-02-05 14:14 ` Grant Likely
2013-02-05 20:06 ` Jean-Christophe PLAGNIOL-VILLARD [this message]
2013-02-06 8:33 ` Yang, Wenyou
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20130205200649.GD30595@game.jcrosoft.org \
--to=plagnioj@jcrosoft.com \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox