Re: [PATCH v5 2/4] arm64: dts: ti: k3-am62x-sk-common: Remove the unused cfg in USB1_DRVVBUS

[Kendall Willis <k-willis@ti.com>]

On 9/5/25 00:14, Akashdeep Kaur wrote:
> After the SoC has entered the DeepSleep low power mode, USB1 can be
> used to wakeup the SoC based on USB events triggered by USB devices.
> This requires that the pin corresponding to the Type-A connector
> remains pulled up even after the SoC has entered the DeepSleep low power
> mode.
> For that, either DeepSleep pullup configuration can be selected or the pin
> can have the same configuration that it had when SoC was in active mode.
> But, in order for DeepSleep configuration to take effect, the DeepSleep
> control bit has to be enabled.
> Remove the unnecessary DeepSleep state configuration from USB1_DRVBUS pin,
> as the DeepSleep control bit is not set and the active configuration is
> sufficient to keep the pin pulled up. This simplifies the setup and removes
> redundant configuration.
> 
> This reverts commit 527f884d2d94981016e181dcbd4c4b5bf597c0ad.
> 
> Reviewed-by: Dhruva Gole <d-gole@ti.com>
> Signed-off-by: Akashdeep Kaur <a-kaur@ti.com>

Verified USB disconnect, USB connect, and USB remote wakeup on SK-AM62B-P1.

Tested-by: Kendall Willis <k-willis@ti.com>

> ---
>   arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi b/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi
> index 13e1d36123d5..d3bed23134ca 100644
> --- a/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi
> @@ -249,7 +249,7 @@ AM62X_IOPAD(0x12c, PIN_OUTPUT, 0) /* (AD19/V15) RGMII1_TX_CTL */
>   
>   	main_usb1_pins_default: main-usb1-default-pins {
>   		pinctrl-single,pins = <
> -			AM62X_IOPAD(0x0258, PIN_OUTPUT | PIN_DS_PULLUD_ENABLE | PIN_DS_PULL_UP, 0) /* (F18/E16) USB1_DRVVBUS */
> +			AM62X_IOPAD(0x0258, PIN_OUTPUT, 0) /* (F18/E16) USB1_DRVVBUS */
>   		>;
>   	};
>