[PATCH v4 0/2] media: add Himax HM1246 image sensor

[Matthias Fend <matthias.fend@emfend.at>]

Hello,

this series adds support for the Himax HM1246 image sensor.
The Himax HM1246-AWD is a 1/3.7-Inch CMOS image sensor SoC with an active
array size of 1296 x 976.
Currently, only the native RAW mode is supported. Other modes and the
internal image signal processing pipeline are not currently supported.
The data sheet is available on the manufacturer's website [1].
Tested on i.MX8MP hardware. A Toshiba TC358746 bridge was used to convert
the sensor's parallel video output into MIPI signals for the i.MX8MP.

Best regards
 ~Matthias
 
[1] https://www.himax.com.tw/wp-content/uploads/2024/03/HM1246-AWD_DS_v01.pdf

v4l2-compliance 1.28.1, 64 bits, 64-bit time_t

Compliance test for device /dev/v4l-subdev4:

Driver Info:
        Driver version   : 6.12.0
        Capabilities     : 0x00000000
        Client Capabilities: 0x0000000000000003
streams interval-uses-which
Required ioctls:
        test VIDIOC_SUDBEV_QUERYCAP: OK
        test invalid ioctls: OK

Allow for multiple opens:
        test second /dev/v4l-subdev4 open: OK
        test VIDIOC_SUBDEV_QUERYCAP: OK
        test for unlimited opens: OK

Debug ioctls:
        test VIDIOC_LOG_STATUS: OK (Not Supported)

Input ioctls:
        test VIDIOC_G/S_TUNER/ENUM_FREQ_BANDS: OK (Not Supported)
        test VIDIOC_G/S_FREQUENCY: OK (Not Supported)
        test VIDIOC_S_HW_FREQ_SEEK: OK (Not Supported)
        test VIDIOC_ENUMAUDIO: OK (Not Supported)
        test VIDIOC_G/S/ENUMINPUT: OK (Not Supported)
        test VIDIOC_G/S_AUDIO: OK (Not Supported)
        Inputs: 0 Audio Inputs: 0 Tuners: 0

Output ioctls:
        test VIDIOC_G/S_MODULATOR: OK (Not Supported)
        test VIDIOC_G/S_FREQUENCY: OK (Not Supported)
        test VIDIOC_ENUMAUDOUT: OK (Not Supported)
        test VIDIOC_G/S/ENUMOUTPUT: OK (Not Supported)
        test VIDIOC_G/S_AUDOUT: OK (Not Supported)
        Outputs: 0 Audio Outputs: 0 Modulators: 0

Input/Output configuration ioctls:
        test VIDIOC_ENUM/G/S/QUERY_STD: OK (Not Supported)
        test VIDIOC_ENUM/G/S/QUERY_DV_TIMINGS: OK (Not Supported)
        test VIDIOC_DV_TIMINGS_CAP: OK (Not Supported)
        test VIDIOC_G/S_EDID: OK (Not Supported)

Control ioctls:
        test VIDIOC_QUERY_EXT_CTRL/QUERYMENU: OK
        test VIDIOC_QUERYCTRL: OK
        test VIDIOC_G/S_CTRL: OK
        test VIDIOC_G/S/TRY_EXT_CTRLS: OK
        test VIDIOC_(UN)SUBSCRIBE_EVENT/DQEVENT: OK
        test VIDIOC_G/S_JPEGCOMP: OK (Not Supported)
        Standard Controls: 15 Private Controls: 0

Format ioctls:
        test VIDIOC_ENUM_FMT/FRAMESIZES/FRAMEINTERVALS: OK (Not Supported)
        test VIDIOC_G/S_PARM: OK (Not Supported)
        test VIDIOC_G_FBUF: OK (Not Supported)
        test VIDIOC_G_FMT: OK (Not Supported)
        test VIDIOC_TRY_FMT: OK (Not Supported)
        test VIDIOC_S_FMT: OK (Not Supported)
        test VIDIOC_G_SLICED_VBI_CAP: OK (Not Supported)
        test Cropping: OK (Not Supported)
        test Composing: OK (Not Supported)
        test Scaling: OK (Not Supported)

Codec ioctls:
        test VIDIOC_(TRY_)ENCODER_CMD: OK (Not Supported)
        test VIDIOC_G_ENC_INDEX: OK (Not Supported)
        test VIDIOC_(TRY_)DECODER_CMD: OK (Not Supported)

Buffer ioctls:
        test VIDIOC_REQBUFS/CREATE_BUFS/QUERYBUF: OK (Not Supported)
        test CREATE_BUFS maximum buffers: OK
        test VIDIOC_REMOVE_BUFS: OK
        test VIDIOC_EXPBUF: OK (Not Supported)
        test Requests: OK (Not Supported)

Total for device /dev/v4l-subdev4: 45, Succeeded: 45, Failed: 0, Warnings: 0

Signed-off-by: Matthias Fend <matthias.fend@emfend.at>
---
Changes in v4:
- Split changes to MAINTAINERS into commits
- Fix comma after statement (use semicolon)
- Replace abs() with abs_diff() in PLL calculation
- Inverse needs_cmu_update logic
- Drop mode from hm1246_set_ctrl()
- Return if xclk frequency is out of range
- Fix reset_gpio dev_err_probe()
- Rebased on media-committers/next
- Link to v3: https://lore.kernel.org/r/20250912-hm1246-v3-0-3b89f47dfa43@emfend.at

Changes in v3:
- Bindings: Remove bus-type and add default polarity values
- Select V4L2_CCI_I2C
- Convert additional macros to use HZ_PER_*
- Replace cur_mode with v4l2_find_nearest_size()
- Remove duplicates in the register init sequence
- Use container_of_const
- Check return of hm1246_update_controls()
- Correct multi-line comments
- Replace hm1246_cci_write_cmu()
- Consistently use hm1246->dev
- Use pm_runtime_put_autosuspend()
- Remove v4l2 event handling
- Convert to devm_v4l2_sensor_clk_get()
- Configure PM before registering subdev
- Link to v2: https://lore.kernel.org/r/20250526-hm1246-v2-0-6b882827a3a5@emfend.at
- Depends-on: https://lore.kernel.org/all/20250707143253.167910-1-mehdi.djait@linux.intel.com/

Changes in v2:
- Use macros for 64-bit division
- Avoid compiler warnings about potentially uninitialized variables
- Fix two uses of dev_err_probe
- Link to v1: https://lore.kernel.org/r/20250403-hm1246-v1-0-30990d71bc42@emfend.at

---
Matthias Fend (2):
      media: dt-bindings: i2c: add Himax HM1246 image sensor
      media: i2c: add Himax HM1246 image sensor driver

 .../bindings/media/i2c/himax,hm1246.yaml           |  113 ++
 MAINTAINERS                                        |    8 +
 drivers/media/i2c/Kconfig                          |   10 +
 drivers/media/i2c/Makefile                         |    1 +
 drivers/media/i2c/hm1246.c                         | 1422 ++++++++++++++++++++
 5 files changed, 1554 insertions(+)
---
base-commit: 1fdb55ed40fa5ebe6934bd6b93036c714ebb5ef8
change-id: 20250403-hm1246-96b0cdab773c

Best regards,
-- 
Matthias Fend <matthias.fend@emfend.at>