[PATCH v3 0/3] spacemit: k1: Add support for Banana Pi BPI-CM6 IO board

[Junhui Liu <junhui.liu@pigmoral.tech>]

This adds initial support for the Banana Pi BPI-CM6 IO board. The
BPI-CM6 is an industrial-grade RISC-V compute module powered by the
SpacemiT K1 SoC, featuring board-to-board connectors similar to the
Raspberry Pi CM4 form factor. For evaluation and development, the module
is paired with a companion IO carrier board.

During the board bring-up, GPIO45 and GPIO46 were found to be used by
the BPI-CM6 hardware as Ethernet PHY reset GPIOs, while the common K1
GMAC pinctrl groups currently mux them as optional GMAC reference clock
pins. Since the reference clock pins are not required on all K1 boards,
the second patch separates them into independent pinctrl groups so board
DTS files can select them only when the signal is actually wired.

Link: https://docs.banana-pi.org/en/BPI-CM6/BananaPi_BPI-CM6
Signed-off-by: Junhui Liu <junhui.liu@pigmoral.tech>
---
Changes in v3:
- Remove uncontrolled always-on intermediate fixed regulators to
  reduce device tree bloat
- Rebase to v7.2-rc1
- Link to v2: https://lore.kernel.org/r/20260528-bpi-cm6-v2-0-d0eb3f236cea@pigmoral.tech

Changes in v2:
- Keep gmac_clk_ref pinctrl groups referenced on existing boards where
  the pins are routed to optional PHY refclk paths
- Remove duplicate vpcie3v3-supply property from pcie1 and pcie2 nodes
- Collect tags
- Link to v1: https://lore.kernel.org/r/20260522-bpi-cm6-v1-0-707ef1917a30@pigmoral.tech

---
Junhui Liu (3):
      dt-bindings: riscv: spacemit: Add Banana Pi BPI-CM6 compatible
      riscv: dts: spacemit: k1: Split gmac_clk_ref into independent pinctrl groups
      riscv: dts: spacemit: k1: Add Banana Pi BPI-CM6 IO board

 .../devicetree/bindings/riscv/spacemit.yaml        |   5 +
 arch/riscv/boot/dts/spacemit/Makefile              |   1 +
 .../riscv/boot/dts/spacemit/k1-bananapi-cm6-io.dts | 177 +++++++++++++++++
 arch/riscv/boot/dts/spacemit/k1-bananapi-cm6.dtsi  | 217 +++++++++++++++++++++
 arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts    |   4 +-
 arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts  |   4 +-
 arch/riscv/boot/dts/spacemit/k1-musepi-pro.dts     |   2 +-
 arch/riscv/boot/dts/spacemit/k1-orangepi-r2s.dts   |   4 +-
 arch/riscv/boot/dts/spacemit/k1-pinctrl.dtsi       |  24 ++-
 9 files changed, 427 insertions(+), 11 deletions(-)
---
base-commit: dc59e4fea9d83f03bad6bddf3fa2e52491777482
change-id: 20260522-bpi-cm6-dc38f91e3fec

Best regards,
--  
Junhui Liu <junhui.liu@pigmoral.tech>