Re: [PATCH v3 11/11] platform/x86: int3472/discrete: Get the polarity from the _DSM entry

[Andy Shevchenko <andy@kernel.org>]

On Fri, Dec 16, 2022 at 12:30:13PM +0100, Hans de Goede wrote:
> According to:
> https://github.com/intel/ipu6-drivers/blob/master/patch/int3472-support-independent-clock-and-LED-gpios-5.17%2B.patch
> 
> Bits 31-24 of the _DSM pin entry integer value codes the active-value,

Here and in the code you actually can refer to it as 3rd byte.

> that is the actual physical signal (0 or 1) which needs to be output on
> the pin to turn the sensor chip on (to make it active).
> 
> So if bits 31-24 are 0 for a reset pin, then the actual value of the reset
> pin needs to be 0 to take the chip out of reset. IOW in this case the reset
> signal is active-high rather then the default active-low.
> 
> And if bits 31-24 are 0 for a clk-en pin then the actual value of the clk
> pin needs to be 0 to enable the clk. So in this case the clk-en signal
> is active-low rather then the default active-high.
> 
> IOW if bits 31-24 are 0 for a pin, then the default polarity of the pin
> is inverted.
> 
> Add a check for this and also propagate this new polarity to the clock
> registration.

...

> +	/* If bits 31-24 of the _DSM entry are all 0 then the signal is inverted */

> +	active_value = obj->integer.value >> 24;
> +	if (!active_value)

Not sure why you need a temporary variable for this. Just use
GENMASK()/GENMASK_ULL()?

	if (obj->integer.value & GENMASK(31, 24));

In this case you even don't need to repeat bit numbers in the comment.

> +		polarity ^= GPIO_ACTIVE_LOW;

> +	dev_dbg(int3472->dev, "%s %s pin %d active-%s\n", func,
> +		agpio->resource_source.string_ptr, agpio->pin_table[0],
> +		(polarity == GPIO_ACTIVE_HIGH) ? "high" : "low");

Yet another high/low :-)

-- 
With Best Regards,
Andy Shevchenko