Linux Media Controller development
 help / color / mirror / Atom feed
From: Sakari Ailus <sakari.ailus@linux.intel.com>
To: linux-media@vger.kernel.org
Cc: laurent.pinchart@ideasonboard.com,
	Dave Stevenson <dave.stevenson@raspberrypi.com>,
	Jacopo Mondi <jacopo.mondi@ideasonboard.com>,
	Tomi Valkeinen <tomi.valkeinen@ideasonboard.com>,
	Jai Luthra <jai.luthra@ideasonboard.com>,
	Mehdi Djait <mehdi.djait@linux.intel.com>,
	Frank Li <Frank.li@nxp.com>
Subject: [PATCH v2 15/17] media: ti: cal: Use v4l2_subdev_get_frame_desc()
Date: Mon, 18 May 2026 19:43:15 +0300	[thread overview]
Message-ID: <20260518164318.3367888-16-sakari.ailus@linux.intel.com> (raw)
In-Reply-To: <20260518164318.3367888-1-sakari.ailus@linux.intel.com>

Call v4l2_subdev_get_frame_desc() to obtain the frame descriptor. This is
preferred over calling the get_frame_desc() pad operation directly.

Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
---
 drivers/media/platform/ti/cal/cal-camerarx.c | 26 +++++++++-----------
 1 file changed, 12 insertions(+), 14 deletions(-)

diff --git a/drivers/media/platform/ti/cal/cal-camerarx.c b/drivers/media/platform/ti/cal/cal-camerarx.c
index 00a71dac0ff4..9ea1f3551d22 100644
--- a/drivers/media/platform/ti/cal/cal-camerarx.c
+++ b/drivers/media/platform/ti/cal/cal-camerarx.c
@@ -9,6 +9,7 @@
  *	Laurent Pinchart <laurent.pinchart@ideasonboard.com>
  */
 
+#include <linux/cleanup.h>
 #include <linux/clk.h>
 #include <linux/delay.h>
 #include <linux/mfd/syscon.h>
@@ -872,7 +873,8 @@ static int cal_camerarx_get_frame_desc(struct v4l2_subdev *sd, unsigned int pad,
 				       struct v4l2_mbus_frame_desc *fd)
 {
 	struct cal_camerarx *phy = to_cal_camerarx(sd);
-	struct v4l2_mbus_frame_desc remote_desc;
+	struct v4l2_mbus_frame_desc *remote_desc
+		__free(v4l2_subdev_free_frame_desc) = NULL;
 	const struct media_pad *remote_pad;
 	struct v4l2_subdev_state *state;
 	u32 sink_stream;
@@ -893,24 +895,20 @@ static int cal_camerarx_get_frame_desc(struct v4l2_subdev *sd, unsigned int pad,
 		goto out_unlock;
 	}
 
-	ret = v4l2_subdev_call(phy->source, pad, get_frame_desc,
-			       remote_pad->index, &remote_desc);
-	if (ret)
-		goto out_unlock;
-
-	if (remote_desc.type != V4L2_MBUS_FRAME_DESC_TYPE_CSI2) {
-		cal_err(phy->cal,
-			"Frame descriptor does not describe CSI-2 link");
-		ret = -EINVAL;
+	remote_desc =
+		v4l2_subdev_get_frame_desc(phy->source, remote_pad->index,
+					   V4L2_MBUS_FRAME_DESC_TYPE_CSI2);
+	if (IS_ERR(remote_desc)) {
+		ret = PTR_ERR(remote_desc);
 		goto out_unlock;
 	}
 
-	for (i = 0; i < remote_desc.num_entries; i++) {
-		if (remote_desc.entry[i].stream == sink_stream)
+	for (i = 0; i < remote_desc->num_entries; i++) {
+		if (remote_desc->entry[i].stream == sink_stream)
 			break;
 	}
 
-	if (i == remote_desc.num_entries) {
+	if (i == remote_desc->num_entries) {
 		cal_err(phy->cal, "Stream %u not found in remote frame desc\n",
 			sink_stream);
 		ret = -EINVAL;
@@ -919,7 +917,7 @@ static int cal_camerarx_get_frame_desc(struct v4l2_subdev *sd, unsigned int pad,
 
 	fd->type = V4L2_MBUS_FRAME_DESC_TYPE_CSI2;
 	fd->num_entries = 1;
-	fd->entry[0] = remote_desc.entry[i];
+	fd->entry[0] = remote_desc->entry[i];
 
 out_unlock:
 	v4l2_subdev_unlock_state(state);
-- 
2.47.3


  parent reply	other threads:[~2026-05-18 16:43 UTC|newest]

Thread overview: 33+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-05-18 16:43 [PATCH v2 00/17] Rework frame descriptors Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 01/17] media: v4l2-common: Add helper function media_bus_fmt_to_csi2_(bpp|dt)() Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 02/17] media: v4l2-subdev: Align frame descriptor error codes with routing Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 03/17] media: v4l2-subdev: Prepare for changes in getting frame descriptors Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 04/17] media: v4l2-subdev: Allow releasing frame descriptors on return Sakari Ailus
2026-05-19 21:34   ` Frank Li
2026-05-20 12:56     ` Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 05/17] media: v4l2-subdev: Allocate frame descriptors based on the need Sakari Ailus
2026-05-19 21:53   ` Frank Li
2026-05-19 22:18     ` Frank Li
2026-05-18 16:43 ` [PATCH v2 06/17] media: v4l2-subdev: Change the maximum number of routes Sakari Ailus
2026-05-19 21:55   ` Frank Li
2026-05-18 16:43 ` [PATCH v2 07/17] media: v4l2-subdev: Return dynamically allocated pass-through routes Sakari Ailus
2026-05-19 22:33   ` Frank Li
2026-05-20 12:59     ` Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 08/17] media: v4l2-subdev: Always return at least one frame descriptor Sakari Ailus
2026-05-19 22:35   ` Frank Li
2026-05-18 16:43 ` [PATCH v2 09/17] media: bcm2835-unicam: Use v4l2_subdev_get_frame_desc() Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 10/17] media: nxp: imx8-isi: " Sakari Ailus
2026-05-19 22:36   ` Frank Li
2026-05-18 16:43 ` [PATCH v2 11/17] media: raspberrypi: cfe: " Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 12/17] media: rzg2l-cru: " Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 13/17] media: rkisp1: " Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 14/17] media: exynos4-is: " Sakari Ailus
2026-05-18 16:43 ` Sakari Ailus [this message]
2026-05-18 16:43 ` [PATCH v2 16/17] media: ipu6: " Sakari Ailus
2026-05-18 16:43 ` [PATCH v2 17/17] staging: media: ipu7: " Sakari Ailus
2026-06-11 12:49 ` [PATCH v2 00/17] Rework frame descriptors Tomi Valkeinen
2026-06-12  8:28   ` Sakari Ailus
2026-06-23  7:39   ` Sakari Ailus
2026-08-14  8:17 ` Mattijs Korpershoek
2026-08-14  8:21   ` Tomi Valkeinen
2026-08-14  9:26     ` Mattijs Korpershoek

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20260518164318.3367888-16-sakari.ailus@linux.intel.com \
    --to=sakari.ailus@linux.intel.com \
    --cc=Frank.li@nxp.com \
    --cc=dave.stevenson@raspberrypi.com \
    --cc=jacopo.mondi@ideasonboard.com \
    --cc=jai.luthra@ideasonboard.com \
    --cc=laurent.pinchart@ideasonboard.com \
    --cc=linux-media@vger.kernel.org \
    --cc=mehdi.djait@linux.intel.com \
    --cc=tomi.valkeinen@ideasonboard.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox