From: Adrian Hunter <adrian.hunter@nokia.com>
To: Andrew Morton <akpm@linux-foundation.org>
Cc: Jarkko Lavinen <jarkko.lavinen@nokia.com>,
Adrian Hunter <adrian.hunter@nokia.com>,
Madhusudhan Chikkature <madhu.cr@ti.com>,
linux-mmc Mailing List <linux-mmc@vger.kernel.org>,
linux-omap Mailing List <linux-omap@vger.kernel.org>,
Pierre Ossman <pierre@ossman.eu>,
Matt Fleming <matt@console-pimps.org>
Subject: [PATCH V3 10/30] ARM: OMAP: mmc-twl4030: add context loss counter support
Date: Wed, 09 Sep 2009 14:57:47 +0300 [thread overview]
Message-ID: <20090909115747.12833.12983.sendpatchset@ahunter-laptop> (raw)
In-Reply-To: <20090909115633.12833.39619.sendpatchset@ahunter-laptop>
>From 027d57463031f291c704f3048c49765c02e661b1 Mon Sep 17 00:00:00 2001
From: Denis Karpov <ext-denis.2.karpov@nokia.com>
Date: Tue, 7 Jul 2009 15:54:44 +0300
Subject: [PATCH] ARM: OMAP: mmc-twl4030: add context loss counter support
PM dynamic OFF state results in context loss. That is, the host
controller has been powered off at some point, which means the
registers have been reset. The driver must detect when this
happens, and restore the context. This patch adds the means
to detect context loss.
Note, the PM side is not yet implemented.
Signed-off-by: Denis Karpov <ext-denis.2.karpov@nokia.com>
Signed-off-by: Adrian Hunter <adrian.hunter@nokia.com>
---
arch/arm/mach-omap2/mmc-twl4030.c | 15 +++++++++++++++
arch/arm/plat-omap/include/mach/mmc.h | 3 +++
2 files changed, 18 insertions(+), 0 deletions(-)
diff --git a/arch/arm/mach-omap2/mmc-twl4030.c b/arch/arm/mach-omap2/mmc-twl4030.c
index 3c04c2f..30d0286 100644
--- a/arch/arm/mach-omap2/mmc-twl4030.c
+++ b/arch/arm/mach-omap2/mmc-twl4030.c
@@ -198,6 +198,18 @@ static int twl_mmc_resume(struct device *dev, int slot)
#define twl_mmc_resume NULL
#endif
+#if defined(CONFIG_ARCH_OMAP3) && defined(CONFIG_PM)
+
+static int twl4030_mmc_get_context_loss(struct device *dev)
+{
+ /* FIXME: PM DPS not implemented yet */
+ return 0;
+}
+
+#else
+#define twl4030_mmc_get_context_loss NULL
+#endif
+
static int twl_mmc1_set_power(struct device *dev, int slot, int power_on,
int vdd)
{
@@ -390,6 +402,9 @@ void __init twl4030_mmc_init(struct twl4030_hsmmc_info *controllers)
} else
mmc->slots[0].switch_pin = -EINVAL;
+ mmc->get_context_loss_count =
+ twl4030_mmc_get_context_loss;
+
/* write protect normally uses an OMAP gpio */
if (gpio_is_valid(c->gpio_wp)) {
gpio_request(c->gpio_wp, "mmc_wp");
diff --git a/arch/arm/plat-omap/include/mach/mmc.h b/arch/arm/plat-omap/include/mach/mmc.h
index 81d5b36..2f7cf31 100644
--- a/arch/arm/plat-omap/include/mach/mmc.h
+++ b/arch/arm/plat-omap/include/mach/mmc.h
@@ -59,6 +59,9 @@ struct omap_mmc_platform_data {
int (*suspend)(struct device *dev, int slot);
int (*resume)(struct device *dev, int slot);
+ /* Return context loss count due to PM states changing */
+ int (*get_context_loss_count)(struct device *dev);
+
u64 dma_mask;
struct omap_mmc_slot_data {
--
1.5.6.3
next prev parent reply other threads:[~2009-09-09 11:57 UTC|newest]
Thread overview: 33+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-09-09 11:56 [PATCH V3 0/30] mmc and omap_hsmmc patches Adrian Hunter
2009-09-09 11:56 ` [PATCH V3 1/30] mmc: add 'enable' and 'disable' methods to mmc host Adrian Hunter
2009-09-09 11:56 ` [PATCH V3 2/30] mmc: allow host claim / release nesting Adrian Hunter
2009-09-09 11:56 ` [PATCH V3 3/30] mmc: add MMC_CAP_NONREMOVABLE host capability Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 4/30] mmc: add ability to save power by powering off cards Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 5/30] mmc: add mmc card sleep and awake support Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 6/30] mmc: power off once at removal Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 7/30] mmc: check status after MMC SWITCH command Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 8/30] omap_hsmmc: add debugfs entry (host registers) Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 9/30] omap_hsmmc: make use of new enable/disable interface Adrian Hunter
2009-09-09 11:57 ` Adrian Hunter [this message]
2009-09-09 11:57 ` [PATCH V3 11/30] omap_hsmmc: keep track of power mode Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 12/30] omap_hsmmc: context save/restore support Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 13/30] omap_hsmmc: set open drain bit correctly Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 14/30] omap_hsmmc: ensure workqueues are empty before suspend Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 15/30] omap_hsmmc: fix scatter-gather list sanity checking Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 16/30] omap_hsmmc: make use of new MMC_CAP_NONREMOVABLE host capability Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 17/30] omap_hsmmc: support for deeper power saving states Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 18/30] ARM: OMAP: mmc-twl4030: add regulator sleep / wake function Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 19/30] omap_hsmmc: put MMC regulator to sleep Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 20/30] omap_hsmmc: add mmc card sleep and awake support Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 21/30] omap_hsmmc: fix NULL pointer dereference Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 22/30] omap_hsmmc: cleanup macro usage Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 23/30] omap_hsmmc: clear interrupt status after init sequence Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 24/30] omap_hsmmc: cater for weird CMD6 behaviour Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 25/30] omap_hsmmc: prevent races with irq handler Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 26/30] omap_hsmmc: code refactoring Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 27/30] omap_hsmmc: protect the card when the cover is open Adrian Hunter
2009-09-09 12:00 ` [PATCH V3 28/30] omap_hsmmc: ensure all clock enables and disables are paired Adrian Hunter
2009-09-10 22:02 ` Andrew Morton
2009-09-11 8:31 ` Adrian Hunter
2009-09-09 12:00 ` [PATCH V3 29/30] omap_hsmmc: set a large data timeout for commands with busy signal Adrian Hunter
2009-09-09 12:00 ` [PATCH V3 30/30] ARM: OMAP: RX51: set MMC capabilities and power-saving flag Adrian Hunter
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20090909115747.12833.12983.sendpatchset@ahunter-laptop \
--to=adrian.hunter@nokia.com \
--cc=akpm@linux-foundation.org \
--cc=jarkko.lavinen@nokia.com \
--cc=linux-mmc@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=madhu.cr@ti.com \
--cc=matt@console-pimps.org \
--cc=pierre@ossman.eu \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox