From: Adrian Hunter <adrian.hunter@nokia.com>
To: Andrew Morton <akpm@linux-foundation.org>
Cc: Jarkko Lavinen <jarkko.lavinen@nokia.com>,
Adrian Hunter <adrian.hunter@nokia.com>,
Madhusudhan Chikkature <madhu.cr@ti.com>,
Pierre Ossman <pierre@ossman.eu>,
linux-omap Mailing List <linux-omap@vger.kernel.org>,
linux-mmc Mailing List <linux-mmc@vger.kernel.org>,
Matt Fleming <matt@console-pimps.org>
Subject: [PATCH V3 11/30] omap_hsmmc: keep track of power mode
Date: Wed, 09 Sep 2009 14:57:55 +0300 [thread overview]
Message-ID: <20090909115755.12833.10726.sendpatchset@ahunter-laptop> (raw)
In-Reply-To: <20090909115633.12833.39619.sendpatchset@ahunter-laptop>
>From c6da86a98f20740cf1c0944d92934322be6ab699 Mon Sep 17 00:00:00 2001
From: Adrian Hunter <adrian.hunter@nokia.com>
Date: Tue, 7 Jul 2009 16:44:11 +0300
Subject: [PATCH] omap_hsmmc: keep track of power mode
This patch is preparation for adding context save
and restore support.
Keep track of the current power mode so that the
context restore function can avoid restoring the
context for a card if the power has been switched
off. If the power is off, the card must be
reinitialized anyway which will re-establish the
context.
Signed-off-by: Adrian Hunter <adrian.hunter@nokia.com>
---
drivers/mmc/host/omap_hsmmc.c | 27 +++++++++++++++++++--------
1 files changed, 19 insertions(+), 8 deletions(-)
diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
index b1bee52..8a41629 100644
--- a/drivers/mmc/host/omap_hsmmc.c
+++ b/drivers/mmc/host/omap_hsmmc.c
@@ -141,6 +141,7 @@ struct mmc_omap_host {
unsigned int dma_len;
unsigned int dma_sg_idx;
unsigned char bus_mode;
+ unsigned char power_mode;
u32 *buffer;
u32 bytesleft;
int suspended;
@@ -856,16 +857,25 @@ static void omap_mmc_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
unsigned long regval;
unsigned long timeout;
u32 con;
+ int do_send_init_stream = 0;
mmc_host_enable(host->mmc);
- switch (ios->power_mode) {
- case MMC_POWER_OFF:
- mmc_slot(host).set_power(host->dev, host->slot_id, 0, 0);
- break;
- case MMC_POWER_UP:
- mmc_slot(host).set_power(host->dev, host->slot_id, 1, ios->vdd);
- break;
+ if (ios->power_mode != host->power_mode) {
+ switch (ios->power_mode) {
+ case MMC_POWER_OFF:
+ mmc_slot(host).set_power(host->dev, host->slot_id,
+ 0, 0);
+ break;
+ case MMC_POWER_UP:
+ mmc_slot(host).set_power(host->dev, host->slot_id,
+ 1, ios->vdd);
+ break;
+ case MMC_POWER_ON:
+ do_send_init_stream = 1;
+ break;
+ }
+ host->power_mode = ios->power_mode;
}
con = OMAP_HSMMC_READ(host->base, CON);
@@ -931,7 +941,7 @@ static void omap_mmc_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
OMAP_HSMMC_WRITE(host->base, SYSCTL,
OMAP_HSMMC_READ(host->base, SYSCTL) | CEN);
- if (ios->power_mode == MMC_POWER_ON)
+ if (do_send_init_stream)
send_init_stream(host);
if (ios->bus_mode == MMC_BUSMODE_OPENDRAIN)
@@ -1109,6 +1119,7 @@ static int __init omap_mmc_probe(struct platform_device *pdev)
host->slot_id = 0;
host->mapbase = res->start;
host->base = ioremap(host->mapbase, SZ_4K);
+ host->power_mode = -1;
platform_set_drvdata(pdev, host);
INIT_WORK(&host->mmc_carddetect_work, mmc_omap_detect);
--
1.5.6.3
next prev parent reply other threads:[~2009-09-09 11:57 UTC|newest]
Thread overview: 33+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-09-09 11:56 [PATCH V3 0/30] mmc and omap_hsmmc patches Adrian Hunter
2009-09-09 11:56 ` [PATCH V3 1/30] mmc: add 'enable' and 'disable' methods to mmc host Adrian Hunter
2009-09-09 11:56 ` [PATCH V3 2/30] mmc: allow host claim / release nesting Adrian Hunter
2009-09-09 11:56 ` [PATCH V3 3/30] mmc: add MMC_CAP_NONREMOVABLE host capability Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 4/30] mmc: add ability to save power by powering off cards Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 5/30] mmc: add mmc card sleep and awake support Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 6/30] mmc: power off once at removal Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 7/30] mmc: check status after MMC SWITCH command Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 8/30] omap_hsmmc: add debugfs entry (host registers) Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 9/30] omap_hsmmc: make use of new enable/disable interface Adrian Hunter
2009-09-09 11:57 ` [PATCH V3 10/30] ARM: OMAP: mmc-twl4030: add context loss counter support Adrian Hunter
2009-09-09 11:57 ` Adrian Hunter [this message]
2009-09-09 11:58 ` [PATCH V3 12/30] omap_hsmmc: context save/restore support Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 13/30] omap_hsmmc: set open drain bit correctly Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 14/30] omap_hsmmc: ensure workqueues are empty before suspend Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 15/30] omap_hsmmc: fix scatter-gather list sanity checking Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 16/30] omap_hsmmc: make use of new MMC_CAP_NONREMOVABLE host capability Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 17/30] omap_hsmmc: support for deeper power saving states Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 18/30] ARM: OMAP: mmc-twl4030: add regulator sleep / wake function Adrian Hunter
2009-09-09 11:58 ` [PATCH V3 19/30] omap_hsmmc: put MMC regulator to sleep Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 20/30] omap_hsmmc: add mmc card sleep and awake support Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 21/30] omap_hsmmc: fix NULL pointer dereference Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 22/30] omap_hsmmc: cleanup macro usage Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 23/30] omap_hsmmc: clear interrupt status after init sequence Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 24/30] omap_hsmmc: cater for weird CMD6 behaviour Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 25/30] omap_hsmmc: prevent races with irq handler Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 26/30] omap_hsmmc: code refactoring Adrian Hunter
2009-09-09 11:59 ` [PATCH V3 27/30] omap_hsmmc: protect the card when the cover is open Adrian Hunter
2009-09-09 12:00 ` [PATCH V3 28/30] omap_hsmmc: ensure all clock enables and disables are paired Adrian Hunter
2009-09-10 22:02 ` Andrew Morton
2009-09-11 8:31 ` Adrian Hunter
2009-09-09 12:00 ` [PATCH V3 29/30] omap_hsmmc: set a large data timeout for commands with busy signal Adrian Hunter
2009-09-09 12:00 ` [PATCH V3 30/30] ARM: OMAP: RX51: set MMC capabilities and power-saving flag Adrian Hunter
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20090909115755.12833.10726.sendpatchset@ahunter-laptop \
--to=adrian.hunter@nokia.com \
--cc=akpm@linux-foundation.org \
--cc=jarkko.lavinen@nokia.com \
--cc=linux-mmc@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=madhu.cr@ti.com \
--cc=matt@console-pimps.org \
--cc=pierre@ossman.eu \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox