Re: [parisc-linux] Help wanted: Getting Matrox Mystique to run on HPPA B2000

Re: [parisc-linux] Help wanted: Getting Matrox Mystique to run on HPPA B2000

[Guy Martin]

[-- Attachment #1.1: Type: text/plain, Size: 6498 bytes --]


Hi,

What about 
video=matroxfb:vesa:0x111,depth:16,mem:4,noaccel,init console=tty0
passed to the kernel or something which best correspond to your vga card ?

Mine is this :
0000:02:03.0 VGA compatible controller: Matrox Graphics, Inc. MGA 1064SG [Mystique] (rev 02)
and it works fine.

Guy


On Tue, 05 Jul 2005 22:47:16 +0800
"J. L. Lee" <jllee@singnet.com.sg> wrote:

> Hi,
> 
> I have set up Matrox Millennum II on B2000 running Linux 2.6.12-rc6-pa1 
> kernel. Am now trying to set up Matrox Mystique to run on it too.
> 
> In my first attempt I compiled the "Matrox acceleration" as MODULE with 
> "Millennium I/II support" and "Mystique support" compiled into the KERNEL 
> (they are not "module" selectable). After rebooting, 'matroxfb' was not 
> loaded automatically. Executed a command "modprobe matroxfb" it returned an 
> error msg "FATAL: Module matroxfb not found".
> 
> Recompiled the second time with "Matrox acceleration", "Millennium I/II 
> support" and "Mystique support" all compiled into the KERNEL. Rebooted 
> successfully but the Mystique card was not initialized nor the kernel 
> crashes as it did running Linux 2.6.8.
> 
> The relevant boot msgs are as follows: (3 extra 'printk' s were added to 
> drivers/video/matrox/matroxfb_base.h before kernel recompilation so there 
> are extra outputs)
> 
> 
> STI GSC/PCI core graphics driver Version 0.9a
> STI PCI graphic ROM found at fd820000 (128 kB), fb at fb000000 (16 MB)
>      id 35acda16-9a02587, conforms to spec rev. 8.0c
>      graphics card name: HPA4982A
> sticon: Initializing STI text console.
> Console: switching to colour STI console 160x64
> matroxfb: Matrox Mystique (PCI) detected
> mga_ioremap: phys=4253024256 size=16384 flags=1 virt=104f49e0 
> virt->vaddr=fd800000
> mga_ioremap: phys=4244635648 size=8388608 flags=1 virt=104f49cc 
> virt->vaddr=fd000000
> matroxfb: cannot determine memory size
> mga_iounmap: before iounmap() va->vaddr=fd000000
> mga_iounmap: after iounmap() va->vaddr=fd000000
> mga_iounmap: before iounmap() va->vaddr=fd800000
> mga_iounmap: after iounmap() va->vaddr=fd800000
> matroxfb: probe of 0000:01:01.0 failed with error -1
> stifb: 'HPA4982A' (id: 0x35acda16) not supported.
> Generic RTC Driver v1.07
> 
> 
> The 'lspci -v' outputs are as follows:
> 
> DebianHPPA01:~# lspci -v
> 0000:00:0c.0 Ethernet controller: Digital Equipment Corporation DECchip 
> 21142/43 (rev 41)
> 	Subsystem: Hewlett-Packard Company: Unknown device 104f
> 	Flags: bus master, medium devsel, latency 255, IRQ 66
> 	I/O ports at 0f00 [size=128]
> 	Memory at f4005000 (32-bit, non-prefetchable) [size=1K]
> 	Expansion ROM at f4040000 [disabled] [size=256K]
> 
> 0000:00:0d.0 Multimedia audio controller: Analog Devices AD1889 sound chip
> 	Subsystem: Analog Devices AD1889 sound chip
> 	Flags: bus master, medium devsel, latency 255, IRQ 67
> 	Memory at f4009000 (32-bit, prefetchable) [size=512]
> 	Memory at f4008000 (32-bit, prefetchable) [size=16]
> 	Memory at f4007000 (32-bit, prefetchable) [size=16]
> 	Memory at f4006000 (32-bit, prefetchable) [size=16]
> 	Capabilities: [dc] Power Management version 1
> 
> 0000:00:0e.0 IDE interface: National Semiconductor Corporation 87415/87560 
> IDE (rev 03) (prog-if 8f [Master SecP SecO PriP PriO])
> 	Flags: bus master, medium devsel, latency 255, IRQ 7
> 	I/O ports at 0e00 [size=8]
> 	I/O ports at 0d00 [size=4]
> 	I/O ports at 0b00 [size=8]
> 	I/O ports at 0a00 [size=4]
> 	I/O ports at 0900 [size=16]
> 
> 0000:00:0e.1 Bridge: National Semiconductor Corporation 87560 Legacy I/O 
> (rev 01)
> 	Flags: bus master, medium devsel, latency 255, IRQ 68
> 
> 0000:00:0e.2 USB Controller: National Semiconductor Corporation USB 
> Controller (rev 02) (prog-if 10 [OHCI])
> 	Flags: bus master, medium devsel, latency 240, IRQ 1
> 	Memory at f4004000 (32-bit, non-prefetchable) [size=4K]
> 	Memory at f4003000 (32-bit, non-prefetchable) [size=4K]
> 
> 0000:00:0f.0 SCSI storage controller: LSI Logic / Symbios Logic 53c895a 
> (rev 01)
> 	Subsystem: LSI Logic / Symbios Logic LSI53C895A PCI to Ultra2 SCSI Controller
> 	Flags: bus master, medium devsel, latency 255, IRQ 69
> 	I/O ports at 0800 [size=256]
> 	Memory at f4002000 (32-bit, non-prefetchable) [size=1K]
> 	Memory at f4000000 (32-bit, non-prefetchable) [size=8K]
> 	Capabilities: [40] Power Management version 2
> 
> 0000:01:00.0 3D controller: Hewlett-Packard Company Visualize FXe (rev 03)
> 	Subsystem: Hewlett-Packard Company: Unknown device 108c
> 	Flags: bus master, 66MHz, medium devsel, latency 255, IRQ 70
> 	Memory at fb000000 (64-bit, prefetchable) [size=16M]
> 	Memory at fa000000 (64-bit, non-prefetchable) [size=16M]
> 	Expansion ROM at fd820000 [disabled] [size=128K]
> 
> 0000:01:01.0 VGA compatible controller: Matrox Graphics, Inc. MGA 1064SG 
> [Mystique] (rev 02) (prog-if 00 [VGA])
> 	Flags: bus master, stepping, medium devsel, latency 248, IRQ 71
> 	Memory at fd800000 (32-bit, non-prefetchable) [size=16K]
> 	Memory at fd000000 (32-bit, prefetchable) [size=8M]
> 	Memory at f4800000 (32-bit, non-prefetchable) [size=8M]
> 	Expansion ROM at fd820000 [disabled] [size=64K]
> 
> 
> The 'cat /proc/iomem' outputs are as follows:
> 
> DebianHPPA01:~# cat /proc/iomem
> 00000000-0fffffff : System RAM
>    00000000-000009ff : PDC data (Page Zero)
>    00100000-0039cfff : Kernel code
>    0039d000-0050d89b : Kernel data
> f05d0000-f05d0000 : lcd_data
> f05d0008-f05d0008 : lcd_cmd
> f4000000-f47fffff : PCI00 LMMIO
>    f4000000-f4001fff : sym53c8xx
>    f4002000-f40023ff : sym53c8xx
>    f4004000-f4004fff : ohci_hcd
>    f4005000-f40053ff : tulip
>    f4009000-f40091ff : ad1889
> f4800000-f4ffffff : PCI01 LMMIO
> fd000000-fdffffff : PCI01 ELMMIO
> fed00000-fed00fff : SBA
> fed30000-fed30fff : LBA
> fed32000-fed32fff : LBA
> fef00000-feffffff : Astro Intr Ack
> fff80000-fffaffff : Central Bus
>    fffa0000-fffa0fff : CPU
> fffb0000-fffdffff : Local Broadcast
> fffe0000-ffffffff : Global Broadcast
> DebianHPPA01:~#
> 
> 
> Any suggestion what should I do next to see if Matrox Mytique cards are 
> indeed usable on HPPA boxes.
> 
> Tks,
> Lee
> 
> 
> 
> _______________________________________________
> parisc-linux mailing list
> parisc-linux@lists.parisc-linux.org
> http://lists.parisc-linux.org/mailman/listinfo/parisc-linux


-- 
Guy Martin
Gentoo Linux - HPPA port Lead / IPv6 team

[-- Attachment #1.2: Type: application/pgp-signature, Size: 189 bytes --]

[-- Attachment #2: Type: text/plain, Size: 169 bytes --]

_______________________________________________
parisc-linux mailing list
parisc-linux@lists.parisc-linux.org
http://lists.parisc-linux.org/mailman/listinfo/parisc-linux

Re: [parisc-linux] Help wanted: Getting Matrox Mystique to run on HPPA B2000

[Max Grabert]

On 05/07/05, Guy Martin <gmsoft@gentoo.org> wrote:
>=20
> What about
> video=3Dmatroxfb:vesa:0x111,depth:16,mem:4,noaccel,init console=3Dtty0
> passed to the kernel or something which best correspond to your vga card =
?
>=20
> Mine is this :
> 0000:02:03.0 VGA compatible controller: Matrox Graphics, Inc. MGA 1064SG =
[Mystique] (rev 02)
> and it works fine.

I have a Millenium (I), in my /etc/palo.conf I have
"video=3Dmatroxfb:nomtrr:init:vesa:0x11B:mem:8"

works fine here, too.

   Max
_______________________________________________
parisc-linux mailing list
parisc-linux@lists.parisc-linux.org
http://lists.parisc-linux.org/mailman/listinfo/parisc-linux