[PATCH 00/25] ARM: rockchip: Add peripheral support for RV1106

[PATCH 00/25] ARM: rockchip: Add peripheral support for RV1106

[Vladislav Leonov]

Basic support for the Rockchip RV1106/RV1103 SoCs currently under review.
This series builds on top of that and enables the peripherals needed to
bring up a board beyond a serial console:

 - CRU reset controller support (dt-bindings + clk driver), needed
   by most of the other peripherals below.
 - Ethernet (GMAC) via dwmac-rk.
 - USB2 PHY and USB3-OTG (DWC3).
 - I2C (rk3x).
 - DMA (PL330) + support DMA for the UART nodes.
 - SPI, including a new SCLK_IN_SPI1 clock gate.
 - RNG.
 - SDMMC1.
 - A dts-only quirk (arm,cpu-registers-not-fw-configured) needed on
   the ARM timer node when booting without a secure firmware that
   pre-configures the CPU timer registers.
 - PWM.

Each new dt-binding is added ahead of the driver and dts nodes that
depend on it, so the series bisects cleanly.

This series depends on:
 - "Add support for the Rockchip RV1106 and RV1103" (v3)
   https://lore.kernel.org/all/20260729133609.3465563-1-sjg@chromium.org

 - "pinctrl: Add support for the Rockchip RV1106" (v3)
   https://lore.kernel.org/all/20260729132736.3807082-1-sjg@chromium.org

Testing: boot-tested on custom RV1106 board, with every peripheral
touched by this series: reset/CRU, Ethernet, USB2 PHY/USB3 DWC3,
I2C, DMA+UART, SPI, RNG, SDMMC1 and PWM - exercised and confirmed working.


Vladislav Leonov (25):
  dt-bindings: reset: Add RV1106 CRU reset definitions
  clk: rockchip: Add reset controller support for RV1106
  ARM: dts: rockchip: Add reset bindings to RV1106
  dt-bindings: net: rockchip-dwmac: add RV1106 compatible
  net: ethernet: stmicro: stmmac: dwmac-rk: Add RV1106 support
  ARM: dts: rockchip: Add Ethernet GMAC node for RV1106
  dt-bindings: phy: rockchip,inno-usb2phy: Add RV1106 compatible
  phy: rockchip: inno-usb2: Add support for RV1106
  dt-bindings: usb: rockchip,dwc3: add RV1106 SoC support
  ARM: dts: rockchip: Add USB2 PHY and USB3-OTG (DWC3) nodes for RV1106
  dt-bindings: i2c: rk3x: Add RV1106 compatible
  ARM: dts: rockchip: Add I2C nodes for RV1106
  ARM: dts: rockchip: Add DMAC node for RV1106
  ARM: dts: rockchip: Add DMA support to UART nodes
  dt-bindings: clock: rockchip: Add SCLK_IN_SPI1 for RV1106
  clk: rockchip: Add SCLK_IN_SPI1 gate for RV1106
  dt-bindings: spi: rockchip: Add RV1106 compatible
  spi: rockchip: Add support for RV1106
  ARM: dts: rockchip: Add SPI nodes for RV1106
  dt-bindings: rng: rockchip: Add RV1106 compatible
  ARM: dts: rockchip: Add RNG node for RV1106
  ARM: dts: rockchip: Add SDMMC1 node for RV1106
  ARM: dts: rockchip: add arm,cpu-registers-not-fw-configured to RV1106
    timer node
  dt-bindings: pwm: rockchip: Add RV1106 compatible
  ARM: dts: rockchip: Add PWM nodes for RV1106

 .../devicetree/bindings/i2c/i2c-rk3x.yaml     |   1 +
 .../bindings/net/rockchip-dwmac.yaml          |   2 +
 .../bindings/phy/rockchip,inno-usb2phy.yaml   |   9 +-
 .../devicetree/bindings/pwm/pwm-rockchip.yaml |   8 +
 .../bindings/rng/rockchip,rk3588-rng.yaml     |  11 +-
 .../devicetree/bindings/spi/spi-rockchip.yaml |   5 +
 .../bindings/usb/rockchip,dwc3.yaml           |  35 +-
 arch/arm/boot/dts/rockchip/rv1106.dtsi        | 426 ++++++++++++++++++
 drivers/clk/rockchip/Makefile                 |   2 +-
 drivers/clk/rockchip/clk-rv1106.c             |   4 +
 drivers/clk/rockchip/clk.h                    |   1 +
 drivers/clk/rockchip/rst-rv1106.c             | 340 ++++++++++++++
 .../net/ethernet/stmicro/stmmac/dwmac-rk.c    |  55 +++
 drivers/phy/rockchip/phy-rockchip-inno-usb2.c |  76 ++++
 drivers/spi/spi-rockchip.c                    |   1 +
 .../dt-bindings/clock/rockchip,rv1106-cru.h   |   2 +
 .../dt-bindings/reset/rockchip,rv1106-cru.h   | 305 +++++++++++++
 17 files changed, 1272 insertions(+), 11 deletions(-)
 create mode 100644 drivers/clk/rockchip/rst-rv1106.c
 create mode 100644 include/dt-bindings/reset/rockchip,rv1106-cru.h

---
base-commit: ac414f5eda0814030636177593400acdacfe5e1e
branch: rv1106

-- 
2.47.3

[PATCH 24/25] dt-bindings: pwm: rockchip: Add RV1106 compatible

[Vladislav Leonov]

Add the compatible for the PWM of the RV1106 which is compatible
with RK3328 vatiant.

RV1106 PWM channels also wire up an interrupt line each, with the
channel that supports capture mode using a second one for that.
Add "interrupts" to the schema to describe this.

Signed-off-by: Vladislav Leonov <vlad@zlab.su>
---

 Documentation/devicetree/bindings/pwm/pwm-rockchip.yaml | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/Documentation/devicetree/bindings/pwm/pwm-rockchip.yaml b/Documentation/devicetree/bindings/pwm/pwm-rockchip.yaml
index c8cdfb723336..8fa75cabf025 100644
--- a/Documentation/devicetree/bindings/pwm/pwm-rockchip.yaml
+++ b/Documentation/devicetree/bindings/pwm/pwm-rockchip.yaml
@@ -34,12 +34,20 @@ properties:
               - rockchip,rk3562-pwm
               - rockchip,rk3568-pwm
               - rockchip,rk3588-pwm
+              - rockchip,rv1106-pwm
               - rockchip,rv1126-pwm
           - const: rockchip,rk3328-pwm
 
   reg:
     maxItems: 1
 
+  interrupts:
+    minItems: 1
+    maxItems: 2
+    description:
+      Some PWM channels (e.g. on rockchip,rv1106-pwm) additionally
+      support capture mode and use a second interrupt for that.
+
   clocks:
     minItems: 1
     maxItems: 2
-- 
2.47.3

Re: [PATCH 00/25] ARM: rockchip: Add peripheral support for RV1106

[Jakub Kicinski]

On Mon, 10 Aug 2026 15:10:51 +0300 Vladislav Leonov wrote:
> Basic support for the Rockchip RV1106/RV1103 SoCs currently under review.
> This series builds on top of that and enables the peripherals needed to
> bring up a board beyond a serial console:

Don't expect maintainers to dig out patches for their subsystems
from a big series. This is not how upstream development works.
Repost 4+5 as a separate series to networking..