From: Robert Love <robert.w.love@intel.com>
To: james.bottomley@hansenpartnership.com, linux-scsi@vger.kernel.org
Subject: [PATCH 00/24] libfc and fcoe fixes for 2.6.29-rc
Date: Fri, 27 Feb 2009 10:54:30 -0800 [thread overview]
Message-ID: <20090227185430.25509.34309.stgit@fritz> (raw)
The following series implements fixes for Open-FCoE (libfc and fcoe).
All of these patches had been sent to linux-scsi previously, with the
exception of the last 6 patches, which are new.
Of the last 6 patches one is a patch mailed to linux-scsi, not from
Open-FCoE.org, that has not been applied yet. That patch is-
Roel Kluin - fcoe: fix kfree(skb)
Also, the very last patch converts the FCoE Rx threads to a nice value
of -20. I sought advice on linux-scsi to determine a good value for
these threads, but didn't get feedback. Since other FC driver threads
use -20, this is the value I chose. If this is not a good starting
value, then please do not apply the patch, but I would appreciate
feedback as to a better value.
This patch set is based on Linus' 2.6.29-rc6 tree. I chose this tree
becuase it is more current than rc-fixes. If a rebase and resend is
let me know.
---
Abhijeet Joglekar (2):
libfc: when rport goes away (re-plogi), clean up exchanges to/from rport
libfc: Pass lport in exch_mgr_reset
Chris Leech (2):
fcoe: fix handling of pending queue, prevent out of order frames (v3)
libfc: rport retry on LS_RJT from certain ELS
Robert Love (11):
fcoe: Change fcoe receive thread nice value from 19 (lowest priority) to -20
fcoe: Correct fcoe_transports initialization vs. registration
fcoe: Use setup_timer() and mod_timer()
libfc, fcoe: Remove unnecessary cast by removing inline wrapper
libfc, fcoe: Cleanup function formatting and minor typos
libfc, fcoe: Fix kerneldoc comments
libfc: Cleanup libfc_function_template comments
libfc: check for err when recv and state is incorrect
libfc: rename rp to rdata in fc_disc_new_target()
libfc: correct RPORT_TO_PRIV usage
libfc: Don't violate transport template for rogue port creation
Roel Kluin (1):
fcoe: fix kfree(skb)
Steve Ma (1):
libfc: exch mgr is freed while lport still retrying sequences
Vasu Dev (5):
fcoe: Out of order tx frames was causing several check condition SCSI status
libfc: fixed a read IO data integrity issue when a IO data frame lost
libfc, fcoe: fixed locking issues with lport->lp_mutex around lport->link_status
libfc: fixed a soft lockup issue in fc_exch_recv_abts
libfc: handle RRQ exch timeout
Yi Zou (2):
fcoe: ETH_P_8021Q is already in if_ether and fcoe is not using it anyway
libfc: do not change the fh_rx_id of a recevied frame
drivers/scsi/fcoe/fc_transport_fcoe.c | 91 +++++----
drivers/scsi/fcoe/fcoe_sw.c | 56 +++---
drivers/scsi/fcoe/libfcoe.c | 318 ++++++++++++++-------------------
drivers/scsi/libfc/fc_disc.c | 63 +++----
drivers/scsi/libfc/fc_exch.c | 32 +--
drivers/scsi/libfc/fc_fcp.c | 56 +++---
drivers/scsi/libfc/fc_lport.c | 173 ++++++++----------
drivers/scsi/libfc/fc_rport.c | 197 ++++++++++++--------
include/scsi/fc/fc_fcoe.h | 4
include/scsi/fc/fc_fs.h | 5 +
include/scsi/libfc.h | 138 ++++++++------
include/scsi/libfcoe.h | 9 -
12 files changed, 551 insertions(+), 591 deletions(-)
--
//Rob
next reply other threads:[~2009-02-27 18:54 UTC|newest]
Thread overview: 25+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-02-27 18:54 Robert Love [this message]
2009-02-27 18:54 ` [PATCH 01/24] libfc: Pass lport in exch_mgr_reset Robert Love
2009-02-27 18:54 ` [PATCH 02/24] libfc: when rport goes away (re-plogi), clean up exchanges to/from rport Robert Love
2009-02-27 18:54 ` [PATCH 03/24] libfc: handle RRQ exch timeout Robert Love
2009-02-27 18:54 ` [PATCH 04/24] libfc: fixed a soft lockup issue in fc_exch_recv_abts Robert Love
2009-02-27 18:54 ` [PATCH 05/24] libfc, fcoe: fixed locking issues with lport->lp_mutex around lport->link_status Robert Love
2009-02-27 18:55 ` [PATCH 06/24] libfc: rport retry on LS_RJT from certain ELS Robert Love
2009-02-27 18:55 ` [PATCH 07/24] libfc: fixed a read IO data integrity issue when a IO data frame lost Robert Love
2009-02-27 18:55 ` [PATCH 08/24] libfc: exch mgr is freed while lport still retrying sequences Robert Love
2009-02-27 18:55 ` [PATCH 09/24] libfc: Don't violate transport template for rogue port creation Robert Love
2009-02-27 18:55 ` [PATCH 10/24] libfc: correct RPORT_TO_PRIV usage Robert Love
2009-02-27 18:55 ` [PATCH 11/24] libfc: rename rp to rdata in fc_disc_new_target() Robert Love
2009-02-27 18:55 ` [PATCH 12/24] libfc: check for err when recv and state is incorrect Robert Love
2009-02-27 18:55 ` [PATCH 13/24] libfc: Cleanup libfc_function_template comments Robert Love
2009-02-27 18:55 ` [PATCH 14/24] libfc, fcoe: Fix kerneldoc comments Robert Love
2009-02-27 18:55 ` [PATCH 15/24] libfc, fcoe: Cleanup function formatting and minor typos Robert Love
2009-02-27 18:55 ` [PATCH 16/24] libfc, fcoe: Remove unnecessary cast by removing inline wrapper Robert Love
2009-02-27 18:56 ` [PATCH 17/24] fcoe: Use setup_timer() and mod_timer() Robert Love
2009-02-27 18:56 ` [PATCH 18/24] fcoe: Correct fcoe_transports initialization vs. registration Robert Love
2009-02-27 18:56 ` [PATCH 19/24] libfc: do not change the fh_rx_id of a recevied frame Robert Love
2009-02-27 18:56 ` [PATCH 20/24] fcoe: ETH_P_8021Q is already in if_ether and fcoe is not using it anyway Robert Love
2009-02-27 18:56 ` [PATCH 21/24] fcoe: fix kfree(skb) Robert Love
2009-02-27 18:56 ` [PATCH 22/24] fcoe: Out of order tx frames was causing several check condition SCSI status Robert Love
2009-02-27 18:56 ` [PATCH 23/24] fcoe: fix handling of pending queue, prevent out of order frames (v3) Robert Love
2009-02-27 18:56 ` [PATCH 24/24] fcoe: Change fcoe receive thread nice value from 19 (lowest priority) to -20 Robert Love
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20090227185430.25509.34309.stgit@fritz \
--to=robert.w.love@intel.com \
--cc=james.bottomley@hansenpartnership.com \
--cc=linux-scsi@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox