[PATCH] ath9k_hw: Fix multicast search for AR9002 family

[PATCH] ath9k_hw: Fix multicast search for AR9002 family

[Sujith Manoharan]

From: Sujith Manoharan <c_manoha@qca.qualcomm.com>

The multicast search bit is disabled for the AR9003
family, but this is required for AR9002 too. Fix this in
the INI override routine.

Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
---
 drivers/net/wireless/ath/ath9k/ar5008_phy.c | 10 +++++++++-
 1 file changed, 9 insertions(+), 1 deletion(-)

diff --git a/drivers/net/wireless/ath/ath9k/ar5008_phy.c b/drivers/net/wireless/ath/ath9k/ar5008_phy.c
index d1acfe9..1576d58 100644
--- a/drivers/net/wireless/ath/ath9k/ar5008_phy.c
+++ b/drivers/net/wireless/ath/ath9k/ar5008_phy.c
@@ -610,7 +610,15 @@ static void ar5008_hw_override_ini(struct ath_hw *ah,
 	REG_SET_BIT(ah, AR_DIAG_SW, (AR_DIAG_RX_DIS | AR_DIAG_RX_ABORT));
 
 	if (AR_SREV_9280_20_OR_LATER(ah)) {
-		val = REG_READ(ah, AR_PCU_MISC_MODE2);
+		/*
+		 * For AR9280 and above, there is a new feature that allows
+		 * Multicast search based on both MAC Address and Key ID.
+		 * By default, this feature is enabled. But since the driver
+		 * is not using this feature, we switch it off; otherwise
+		 * multicast search based on MAC addr only will fail.
+		 */
+		val = REG_READ(ah, AR_PCU_MISC_MODE2) &
+			(~AR_ADHOC_MCAST_KEYID_ENABLE);
 
 		if (!AR_SREV_9271(ah))
 			val &= ~AR_PCU_MISC_MODE2_HWWAR1;
-- 
1.8.3.2