[RFC][PATCH 0/5 v2] adv7511 EDID probing improvements

[John Stultz <john.stultz@linaro.org>]

Wanted to send out v2 of this patch set improving the EDID
probing on the adv7511 used on HiKey.

The first three patches are fixups that are hopefully straight
forward, integrating feedback I got from Laurant.

One of the previous patches that Laurant had concerns about, I
broke into two patches, which are the last two in this series. 
The core issue seems to be something going wrong with the regmap
cache state for the ADV7511_REG_EDID_I2C_ADDR (0x43) register
which results in i2c_transfer errors if we don't do the
regcache_sync/_mark_dirty() calls. I suspect there might be a
better solution there, so suggestions will be very welcome.

Thoughts and feedback would be appreciated!

thanks
-john

Cc: David Airlie <airlied@linux.ie>
Cc: Archit Taneja <architt@codeaurora.org>
Cc: Wolfram Sang <wsa+renesas@sang-engineering.com>
Cc: Lars-Peter Clausen <lars@metafoo.de>
Cc: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Cc: dri-devel@lists.freedesktop.org

Archit Taneja (1):
  drm/bridge: adv7511: Enable HPD interrupts to support hotplug and
    improve monitor detection

John Stultz (4):
  drm/bridge: adv7511: Use work_struct to defer hotplug handing to out
    of irq context
  drm/bridge: adv7511: Switch to using drm_kms_helper_hotplug_event()
  drm/bridge: adv7511: Rework adv7511_power_on/off() so they can be
    reused internally
  drm/bridge: adv7511: Reuse __adv7511_power_on/off() when probing EDID

 drivers/gpu/drm/bridge/adv7511/adv7511.h     |  2 ++
 drivers/gpu/drm/bridge/adv7511/adv7511_drv.c | 49 ++++++++++++++++------------
 2 files changed, 31 insertions(+), 20 deletions(-)

-- 
2.7.4