[PATCH v6 7/8] tty: serial: amba-pl011: unindent pl011_console_get_options function body

["Théo Lebrun" <theo.lebrun@bootlin.com>]

The whole function body is encapsulated inside an if-condition. Reverse
the if logic and early return to remove one indentation level.

Also turn two nested ifs into a single one at the end of the function.

Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Reviewed-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>
Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com>
---
 drivers/tty/serial/amba-pl011.c | 43 ++++++++++++++++++++---------------------
 1 file changed, 21 insertions(+), 22 deletions(-)

diff --git a/drivers/tty/serial/amba-pl011.c b/drivers/tty/serial/amba-pl011.c
index d141af8f8a5f..fe910c5f3489 100644
--- a/drivers/tty/serial/amba-pl011.c
+++ b/drivers/tty/serial/amba-pl011.c
@@ -2363,35 +2363,34 @@ pl011_console_write(struct console *co, const char *s, unsigned int count)
 static void pl011_console_get_options(struct uart_amba_port *uap, int *baud,
 				      int *parity, int *bits)
 {
-	if (pl011_read(uap, REG_CR) & UART01x_CR_UARTEN) {
-		unsigned int lcr_h, ibrd, fbrd;
+	unsigned int lcr_h, ibrd, fbrd;
 
-		lcr_h = pl011_read(uap, REG_LCRH_TX);
+	if (!(pl011_read(uap, REG_CR) & UART01x_CR_UARTEN))
+		return;
 
-		*parity = 'n';
-		if (lcr_h & UART01x_LCRH_PEN) {
-			if (lcr_h & UART01x_LCRH_EPS)
-				*parity = 'e';
-			else
-				*parity = 'o';
-		}
+	lcr_h = pl011_read(uap, REG_LCRH_TX);
 
-		if ((lcr_h & 0x60) == UART01x_LCRH_WLEN_7)
-			*bits = 7;
+	*parity = 'n';
+	if (lcr_h & UART01x_LCRH_PEN) {
+		if (lcr_h & UART01x_LCRH_EPS)
+			*parity = 'e';
 		else
-			*bits = 8;
+			*parity = 'o';
+	}
 
-		ibrd = pl011_read(uap, REG_IBRD);
-		fbrd = pl011_read(uap, REG_FBRD);
+	if ((lcr_h & 0x60) == UART01x_LCRH_WLEN_7)
+		*bits = 7;
+	else
+		*bits = 8;
 
-		*baud = uap->port.uartclk * 4 / (64 * ibrd + fbrd);
+	ibrd = pl011_read(uap, REG_IBRD);
+	fbrd = pl011_read(uap, REG_FBRD);
 
-		if (uap->vendor->oversampling) {
-			if (pl011_read(uap, REG_CR)
-				  & ST_UART011_CR_OVSFACT)
-				*baud *= 2;
-		}
-	}
+	*baud = uap->port.uartclk * 4 / (64 * ibrd + fbrd);
+
+	if (uap->vendor->oversampling &&
+	    (pl011_read(uap, REG_CR) & ST_UART011_CR_OVSFACT))
+		*baud *= 2;
 }
 
 static int pl011_console_setup(struct console *co, char *options)

-- 
2.43.0