[U-Boot] [PATCH v7 3/6] spi: cadence_qspi: fix base trigger address & transfer start address

[Wolfgang Denk <wd@denx.de>]

Dear Vikas Manocha,

In message <1443053976-9112-4-git-send-email-vikas.manocha@st.com> you wrote:
> This patch is to separate the base trigger from the read/write transfer start
> addresses.
...
> diff --git a/drivers/spi/cadence_qspi.c b/drivers/spi/cadence_qspi.c
> index 34a0f46..0d1abc8 100644
> --- a/drivers/spi/cadence_qspi.c
> +++ b/drivers/spi/cadence_qspi.c
> @@ -290,6 +290,8 @@ static int cadence_spi_ofdata_to_platdata(struct udevice *bus)
>  
>  	plat->regbase = (void *)data[0];
>  	plat->ahbbase = (void *)data[2];

I realize this code is not new, but for the sake of consistency, the
above two regbase and ahbbase should also use fdtdec_get_addr() ...

Can you please fix that [and similar things, in case there any]?

Thanks.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"He was so narrow minded he could see through  a  keyhole  with  both
eyes ..."