[U-Boot] [PATCH V2 02/13] mmc: tmio: Switch to clock framework

[Marek Vasut <marek.vasut@gmail.com>]

On 11/02/2018 03:24 AM, Masahiro Yamada wrote:
> On Thu, Nov 1, 2018 at 6:39 PM Marek Vasut <marek.vasut@gmail.com> wrote:
>>
>> Switch the driver to using clk_get_rate()/clk_set_rate() instead of
>> caching the mclk frequency in it's private data. This is required on
>> the SDHI variant of the controller, where the upstream mclk need to
>> be adjusted when using UHS modes.
>>
>> Platforms which do not support clock framework or do not support it
>> in eg. SPL default to 100 MHz clock.
>>
>> Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
>> Cc: Masahiro Yamada <yamada.masahiro@socionext.com>
>> ---
>> V2: Fix build on certain platforms using SPL without clock framework
> 
> 
> No.  Not fixed.
> 
> uniphier_ld4_sld8_defconfig produces the following warning.
> 
> drivers/mmc/uniphier-sd.c: In function ‘uniphier_sd_probe’:
> drivers/mmc/uniphier-sd.c:36:23: warning: unused variable ‘priv’
> [-Wunused-variable]
>   struct tmio_sd_priv *priv = dev_get_priv(dev);

Fixed in V3

-- 
Best regards,
Marek Vasut