Re: [PATCH 8/9] configs: am67a_beagley_ai_a53: Enable additional features

[Andrew Davis <afd@ti.com>]

On 4/11/25 5:57 PM, Nishanth Menon wrote:
> Enable basic efi capsule features, switch over to stdboot, enable
> GPIO, LED and PMIC used on this platform. And enable UHS mode support
> for SD cards in U-Boot.
> 
> Capsule support is still pending.
> 
> Signed-off-by: Nishanth Menon <nm@ti.com>
> ---
>   configs/am67a_beagley_ai_a53_defconfig | 12 +++++++++++-
>   1 file changed, 11 insertions(+), 1 deletion(-)
> 
> diff --git a/configs/am67a_beagley_ai_a53_defconfig b/configs/am67a_beagley_ai_a53_defconfig
> index cbf19a03b136..657920025ad3 100644
> --- a/configs/am67a_beagley_ai_a53_defconfig
> +++ b/configs/am67a_beagley_ai_a53_defconfig
> @@ -32,7 +32,7 @@ CONFIG_AUTOBOOT_KEYED=y
>   CONFIG_AUTOBOOT_PROMPT="Press SPACE to abort autoboot in %d seconds\n"
>   CONFIG_AUTOBOOT_DELAY_STR="d"
>   CONFIG_AUTOBOOT_STOP_STR=" "
> -CONFIG_BOOTCOMMAND="run findfdt; run envboot; run distro_bootcmd"
> +CONFIG_BOOTCOMMAND="run set_led_state_start_load; run envboot; bootflow scan -lb;run set_led_state_fail_load"

nit: should be space after all the last ";" char

Acked-by: Andrew Davis <afd@ti.com>

>   CONFIG_BOARD_LATE_INIT=y
>   CONFIG_SPL_MAX_SIZE=0x58000
>   CONFIG_SPL_PAD_TO=0x0
> @@ -49,7 +49,9 @@ CONFIG_SPL_RAM_DEVICE=y
>   CONFIG_SPL_THERMAL=y
>   CONFIG_SPL_YMODEM_SUPPORT=y
>   CONFIG_CMD_CLK=y
> +CONFIG_CMD_GPIO_READ=y
>   CONFIG_CMD_USB_MASS_STORAGE=y
> +CONFIG_CMD_EFIDEBUG=y
>   CONFIG_OF_CONTROL=y
>   CONFIG_SPL_OF_CONTROL=y
>   CONFIG_OF_UPSTREAM=y
> @@ -81,6 +83,10 @@ CONFIG_SPL_DM_GPIO_LOOKUP_LABEL=y
>   CONFIG_DA8XX_GPIO=y
>   CONFIG_DM_I2C=y
>   CONFIG_SYS_I2C_OMAP24XX=y
> +CONFIG_LED=y
> +CONFIG_SPL_LED=y
> +CONFIG_LED_GPIO=y
> +CONFIG_SPL_LED_GPIO=y
>   CONFIG_DM_MAILBOX=y
>   CONFIG_K3_SEC_PROXY=y
>   CONFIG_I2C_EEPROM=y
> @@ -88,6 +94,7 @@ CONFIG_SPL_I2C_EEPROM=y
>   CONFIG_FS_LOADER=y
>   CONFIG_MMC_IO_VOLTAGE=y
>   CONFIG_SPL_MMC_IO_VOLTAGE=y
> +CONFIG_MMC_UHS_SUPPORT=y
>   CONFIG_MMC_SDHCI=y
>   CONFIG_MMC_SDHCI_ADMA=y
>   CONFIG_SPL_MMC_SDHCI_ADMA=y
> @@ -99,12 +106,15 @@ CONFIG_SPL_PINCTRL=y
>   CONFIG_PINCTRL_SINGLE=y
>   CONFIG_POWER_DOMAIN=y
>   CONFIG_TI_SCI_POWER_DOMAIN=y
> +CONFIG_DM_PMIC=y
> +CONFIG_PMIC_TPS65219=y
>   CONFIG_DM_REGULATOR=y
>   CONFIG_SPL_DM_REGULATOR=y
>   CONFIG_DM_REGULATOR_FIXED=y
>   CONFIG_SPL_DM_REGULATOR_FIXED=y
>   CONFIG_DM_REGULATOR_GPIO=y
>   CONFIG_SPL_DM_REGULATOR_GPIO=y
> +CONFIG_DM_REGULATOR_TPS65219=y
>   CONFIG_K3_SYSTEM_CONTROLLER=y
>   CONFIG_RESET_TI_SCI=y
>   CONFIG_DM_SERIAL=y