[U-Boot] [PATCH v9 10/10] adp-ag101: add board adp-ag101 support

[Wolfgang Denk <wd@denx.de>]

Dear Macpaul Lin,

In message <1304342712-17120-10-git-send-email-macpaul@andestech.com> you wrote:
> Add evaluation board "adp-ag101" aconfiguration file adp-ag101.h.
> Add adp-ag101.c board config and related settings.
> Add board adp-ag101 into boards.cfg
...
> +	if (expected_size != actual_size)
> +		printf("Warning: Only %lu of %lu MiB SDRAM is working\n",
> +				actual_size >> 20, expected_size >> 20);

Please use braces around multi-line statements.

> +	if (banknum == 0) {	/* non-CFI boot flash */
> +		info->portwidth = FLASH_CFI_8BIT;
> +		info->chipwidth = FLASH_CFI_BY8;
> +		info->interface = FLASH_CFI_X8;
> +		return 1;
> +	} else
> +		return 0;

Use braces in both branches.

...
> +#define CONFIG_SYS_NS16550_COM1		CONFIG_FTUART010_02_BASE /* 0x99600000 */

Line too long. Please fix globally.

...
> +#define CONFIG_SYS_FTAHBC020S_SLAVE_BSR_6	(FTAHBC020S_SLAVE_BSR_BASE(CONFIG_SYS_FTAHBC020S_SLAVE_BSR_BASE) | \
> +						 FTAHBC020S_SLAVE_BSR_SIZE(FTAHBC020S_SLAVE_BSR_SIZE_2G))

Ditto.

> +/* memtest works on 63 MB in DRAM */
> +#define CONFIG_SYS_MEMTEST_START	0x00000000
> +#define CONFIG_SYS_MEMTEST_END		0x00200000

Comments and code are not in sync.

> +/* relocation parameters */
> +#define CONFIG_SYS_RELO_ADDR		0x10000000

This should go, too.  See previous message.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"There are some good people in it, but the orchestra as  a  whole  is
equivalent to a gang bent on destruction."      - John Cage, composer