Re: [PATCH 2/4] x86/mce/amd: Introduce deferred error interrupt handler

[Borislav Petkov <bp@alien8.de>]

On Mon, May 04, 2015 at 12:08:16PM -0500, Aravind Gopalakrishnan wrote:
> Not sure if lvt_off_valid() can be reused for deferred error interrupt
> setup. It expects some some of info to be in struct threshold_block
> which is fine for threshold errors and the shifts for offset are
> different too.

I meant that thresholding and IBS is being taken care of by that
function.

> For deferred errors, the workaround is a little different as it
> applies to only the given family/model right now. If the workaround
> needs to be applied for future processors, we can extend the family
> check for those right?

Or, you can do the check for all families as we're behind a CPUID bit
anyway. This is why CPUID bits are a good thing :-)

> If we setup 'm.addr' in amd_threshold_interrupt() and
> amd_deferred_error_interrupt() properly, then amd_decode_mce() would
> actually have some value in m->addr to report.
>
> I didn't mean to say HW doesn't provide us the information in the addr
> and/or the misc registers.

So you can use mce_read_aux(), yeah, you can move it to mce-internal.h

> The addr, misc registers are still valid for threshold, deferred errors.
> (Of course, misc is valid only if m->status & MCI_STATUS_MISCV)
> 
> My point was, in __log_error(), we can read relevant status and addr MSRs to
> be passed to mce_log() as those are the only pieces of information we use in
> the decoding chain; and discard the m.misc assignment we do for threshold
> errors.

But MCx_MISC is important for thresholding errors, it carries the ErrCnt
and stuff.

So you can pass a parameter to __log_error(..., threshold=true, misc)
and do

	if (threshold)
		m.misc = misc;

Right?

-- 
Regards/Gruss,
    Boris.

ECO tip #101: Trim your mails when you reply.
--