From: paradoxxa <paradoxxa2001@domain.hid>
To: xenomai@xenomai.org
Subject: Re: [Xenomai-help] at91sam9263 and user-space support compile fails
Date: Mon, 19 May 2008 15:04:45 +0200 [thread overview]
Message-ID: <48317AED.7030507@domain.hid> (raw)
In-Reply-To: <2ff1a98a0805190536q5bb3be8dg9b35265bc5b1b618@domain.hid>
Gilles Chanteperdrix schrieb:
> On Mon, May 19, 2008 at 2:17 PM, paradoxxa <paradoxxa2001@domain.hid> wrote:
>
>
>
> No, you are talking about CONFIG_DEBUG_LL, I am talking about
> CONFIG_DEBUG_INFO. These are two different options. So, this make at
> least two options that you changed. Could you check if a kernel with
> an unmodified defconfig boots ?
>
>
The CONFIG_DEBUG_INFO is already set in the defconfig. The
CONFIG_DEBUG_LL i set manually.
As well I had to changed the AT91 Master Clock Frequency.
Here are the logs of a unmodified defconfig boot:
----------------------------------------------------------------------------------------------------------
Starting kernel ...
Linux version 2.6.24-dienetho-pm9263 (support@domain.hid) (gcc version
4.1.1) #1 Mon May 19 14:48:33
CEST 2008
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
Machine: Ronetix PM9263/BB9263
Ignoring unrecognised tag 0x54410008
Memory policy: ECC disabled, Data cache writeback
Clocks: CPU 199 MHz, master 99 MHz, main 18.432 MHz
CPU0: D VIVT write-back cache
CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets
CPU0: D cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
Kernel command line: root=/dev/mtdblock4 rootfstype=jffs2 fbcon=rotate:3
mtdparts=physmap-flash.0:25
6k(u-boot)ro,64k(u-boot-env)ro,1408k(kernel),-(rootfs);nand:-(nand)
ip=10.0.0.17:10.0.0.20:10.0.0.20
:255.255.255.0:PM9263:eth0:off
AT91: 160 gpio irqs in 5 banks
PID hash table entries: 256 (order: 8, 1024 bytes)
I-pipe 1.9-01: pipeline enabled.
Console: colour dummy device 80x30
console [tty0] enabled
console [ttyS0] enabled
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Kernel panic - not syncing: AT91 clock rate incorrectly set.
Please recompile with IPIPE_AT91_MCK set to 99532800 Hz.
----------------------------------------------------------------------------------------------------------
next prev parent reply other threads:[~2008-05-19 13:04 UTC|newest]
Thread overview: 43+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-05-19 6:26 [Xenomai-help] at91sam9263 and user-space support compile fails Paradoxxa2001
2008-05-19 9:39 ` Gilles Chanteperdrix
2008-05-19 11:20 ` paradoxxa
2008-05-19 12:06 ` Gilles Chanteperdrix
2008-05-19 12:17 ` paradoxxa
2008-05-19 12:36 ` Gilles Chanteperdrix
2008-05-19 13:04 ` paradoxxa [this message]
2008-05-19 13:30 ` Gilles Chanteperdrix
2008-05-19 14:24 ` paradoxxa
2008-05-19 14:28 ` paradoxxa
2008-05-19 14:34 ` Gilles Chanteperdrix
2008-05-20 6:43 ` paradoxxa
2008-05-20 6:52 ` Gilles Chanteperdrix
2008-05-20 8:19 ` Paradoxxa
2008-05-20 8:20 ` Gilles Chanteperdrix
2008-05-20 8:22 ` Gilles Chanteperdrix
2008-05-20 8:23 ` Gilles Chanteperdrix
2008-05-20 12:43 ` Paradoxxa
2008-05-20 15:16 ` Gilles Chanteperdrix
2008-05-21 6:43 ` Paradoxxa
2008-05-21 6:56 ` Gilles Chanteperdrix
-- strict thread matches above, loose matches on Subject: below --
2008-05-16 14:34 Paradoxxa2001
2008-05-16 15:26 ` Gilles Chanteperdrix
2008-05-16 13:53 Paradoxxa2001
2008-05-16 13:57 ` Gilles Chanteperdrix
2008-05-16 14:01 ` Gilles Chanteperdrix
2008-05-16 12:40 Paradoxxa2001
2008-05-16 12:42 ` Gilles Chanteperdrix
2008-05-16 11:07 Paradoxxa2001
2008-05-16 12:18 ` Gilles Chanteperdrix
2008-05-16 9:34 Paradoxxa2001
2008-05-16 9:45 ` Gilles Chanteperdrix
2008-05-16 9:57 ` Gilles Chanteperdrix
2008-05-16 9:24 Paradoxxa2001
2008-05-16 9:27 ` Gilles Chanteperdrix
2008-05-16 9:10 Paradoxxa2001
2008-05-16 9:18 ` Gilles Chanteperdrix
2008-05-16 8:15 Paradoxxa2001
2008-05-16 8:44 ` Gilles Chanteperdrix
2008-05-15 12:28 Paradoxxa2001
2008-05-15 8:36 Paradoxxa2001
2008-05-15 9:21 ` Gilles Chanteperdrix
2008-05-15 9:46 ` Gilles Chanteperdrix
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=48317AED.7030507@domain.hid \
--to=paradoxxa2001@domain.hid \
--cc=xenomai@xenomai.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.