Re: [PATCH 6/7] pinctrl: tegra: Add DT binding for io pads control

[Jon Hunter <jonathanh@nvidia.com>]

On 13/04/16 10:08, Laxman Dewangan wrote:

[snip]

> For T210, 64 bit, it is
>  tegra210.dtsi:    pmc: pmc@0,7000e400 {

Yes and this is wrong [0].

>>> +Required properties:
>>> +- compatible: "nvidia,tegra210-io-pad"
>> I think you have have "Must be ..." here. I am also wondering if the
>> pinctrl device should be registered by the pmc driver and so not a
>> separate driver to the PMC driver. In other words, the PMC driver calls
>> pinctrl_register() directly.
> 
> I like to keep the pmc driver as main interface and other sub
> functionalities like pad control for voltage and power states, no
> iopower control etc as sub drivers. This will help in modular approach
> of the driver.

OK, let's see what Thierry thinks about this.

>>> +The voltage supported on the pads are 1.8V and 3.3V. The enums are
>>> defined as:
>>> +    For 1.8V, use TEGRA210_IO_RAIL_1800000UV
>>> +    For 3.3V, use TEGRA210_IO_RAIL_3300000UV
>> You may consider just using integer values here like we do for
>> regulators.
> 
> We just support two values 1.8V and 3.3V only. I am fine with either way
> also.
> 
>>
>>> +                  TEGRA210_IO_PAD_DEEP_POWER_DOWN_DISABLE for
>>> +                    disable.
>>> +                  TEGRA210_IO_PAD_DEEP_POWER_DOWN_ENABLE for
>>> +                    enable.
>> Sounds like a boolean parameter. So may consider that if the property
>> 'nvidia,io-pad-deep-power-down' is present then it means enable
>> deep-power-down and if not present then don't. Then you do not need to
>> assign a value to it.
> 
> Three states, enable, disable and left default. So absent will be left
> default.

Fine with me.

Cheers
Jon

[0] http://marc.info/?l=linux-tegra&m=146038329109871&w=2