All of lore.kernel.org
 help / color / mirror / Atom feed
From: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
To: dri-devel@lists.freedesktop.org
Cc: Wolfram Sang <wsa+renesas@sang-engineering.com>,
	lkml <linux-kernel@vger.kernel.org>
Subject: Re: [PATCH 0/5 v3] adv7511 EDID probing improvements
Date: Mon, 16 Jan 2017 17:57:02 +0200	[thread overview]
Message-ID: <9649749.TAVrhOzo15@avalon> (raw)
In-Reply-To: <1483472502-16403-1-git-send-email-john.stultz@linaro.org>

Hi John,

Thank you for the patches.

On Tuesday 03 Jan 2017 11:41:37 John Stultz wrote:
> Hope everyone had a good newyears!
> 
> Wanted to re-send out v3 of this patch set improving the EDID
> probing on the adv7511 used on HiKey, for consideration for
> merging for 4.11
> 
> The first three patches are fixups that are hopefully straight
> forward, integrating feedback I got from Laurant.
> 
> The last two patches try to clean up and resue code, which as
> a side effect avoids an issue I'm seeing where something is
> going wrong with the regmap cache state for the
> ADV7511_REG_EDID_I2C_ADDR(0x43) register which results in
> i2c_transfer errors if we don't do the
> regcache_sync/_mark_dirty() calls. I suspect there might be a
> better solution there, but have not gotten any other suggestions
> so I wanted to go ahead and submit these.
> 
> Thoughts and feedback would be appreciated!

For the whole series,

Tested-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>

> New in v3:
> * Addressed naming improvements and drm_kms_helper_hotplug_event
>   usage corrections as suggested by Laurent.
> 
> Cc: David Airlie <airlied@linux.ie>
> Cc: Archit Taneja <architt@codeaurora.org>
> Cc: Wolfram Sang <wsa+renesas@sang-engineering.com>
> Cc: Lars-Peter Clausen <lars@metafoo.de>
> Cc: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
> Cc: dri-devel@lists.freedesktop.org
> 
> Archit Taneja (1):
>   drm/bridge: adv7511: Enable HPD interrupts to support hotplug and
>     improve monitor detection
> 
> John Stultz (4):
>   drm/bridge: adv7511: Use work_struct to defer hotplug handing to out
>     of irq context
>   drm/bridge: adv7511: Switch to using drm_kms_helper_hotplug_event()
>   drm/bridge: adv7511: Rework adv7511_power_on/off() so they can be
>     reused internally
>   drm/bridge: adv7511: Reuse __adv7511_power_on/off() when probing EDID
> 
>  drivers/gpu/drm/bridge/adv7511/adv7511.h     |  2 +
>  drivers/gpu/drm/bridge/adv7511/adv7511_drv.c | 62
> +++++++++++++++++++--------- 2 files changed, 44 insertions(+), 20
> deletions(-)

-- 
Regards,

Laurent Pinchart

_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel

WARNING: multiple messages have this Message-ID (diff)
From: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
To: dri-devel@lists.freedesktop.org
Cc: John Stultz <john.stultz@linaro.org>,
	lkml <linux-kernel@vger.kernel.org>,
	Wolfram Sang <wsa+renesas@sang-engineering.com>
Subject: Re: [PATCH 0/5 v3] adv7511 EDID probing improvements
Date: Mon, 16 Jan 2017 17:57:02 +0200	[thread overview]
Message-ID: <9649749.TAVrhOzo15@avalon> (raw)
In-Reply-To: <1483472502-16403-1-git-send-email-john.stultz@linaro.org>

Hi John,

Thank you for the patches.

On Tuesday 03 Jan 2017 11:41:37 John Stultz wrote:
> Hope everyone had a good newyears!
> 
> Wanted to re-send out v3 of this patch set improving the EDID
> probing on the adv7511 used on HiKey, for consideration for
> merging for 4.11
> 
> The first three patches are fixups that are hopefully straight
> forward, integrating feedback I got from Laurant.
> 
> The last two patches try to clean up and resue code, which as
> a side effect avoids an issue I'm seeing where something is
> going wrong with the regmap cache state for the
> ADV7511_REG_EDID_I2C_ADDR(0x43) register which results in
> i2c_transfer errors if we don't do the
> regcache_sync/_mark_dirty() calls. I suspect there might be a
> better solution there, but have not gotten any other suggestions
> so I wanted to go ahead and submit these.
> 
> Thoughts and feedback would be appreciated!

For the whole series,

Tested-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>

> New in v3:
> * Addressed naming improvements and drm_kms_helper_hotplug_event
>   usage corrections as suggested by Laurent.
> 
> Cc: David Airlie <airlied@linux.ie>
> Cc: Archit Taneja <architt@codeaurora.org>
> Cc: Wolfram Sang <wsa+renesas@sang-engineering.com>
> Cc: Lars-Peter Clausen <lars@metafoo.de>
> Cc: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
> Cc: dri-devel@lists.freedesktop.org
> 
> Archit Taneja (1):
>   drm/bridge: adv7511: Enable HPD interrupts to support hotplug and
>     improve monitor detection
> 
> John Stultz (4):
>   drm/bridge: adv7511: Use work_struct to defer hotplug handing to out
>     of irq context
>   drm/bridge: adv7511: Switch to using drm_kms_helper_hotplug_event()
>   drm/bridge: adv7511: Rework adv7511_power_on/off() so they can be
>     reused internally
>   drm/bridge: adv7511: Reuse __adv7511_power_on/off() when probing EDID
> 
>  drivers/gpu/drm/bridge/adv7511/adv7511.h     |  2 +
>  drivers/gpu/drm/bridge/adv7511/adv7511_drv.c | 62
> +++++++++++++++++++--------- 2 files changed, 44 insertions(+), 20
> deletions(-)

-- 
Regards,

Laurent Pinchart

  parent reply	other threads:[~2017-01-16 15:56 UTC|newest]

Thread overview: 30+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2017-01-03 19:41 [PATCH 0/5 v3] adv7511 EDID probing improvements John Stultz
2017-01-03 19:41 ` [PATCH 1/5 v3] drm/bridge: adv7511: Use work_struct to defer hotplug handing to out of irq context John Stultz
2017-01-03 19:41   ` John Stultz
2017-01-03 19:41 ` [PATCH 2/5 v3] drm/bridge: adv7511: Switch to using drm_kms_helper_hotplug_event() John Stultz
2017-01-03 19:41   ` John Stultz
2017-01-16 15:47   ` Laurent Pinchart
2017-01-16 15:56     ` Laurent Pinchart
2017-01-16 19:31       ` John Stultz
2017-01-03 19:41 ` [PATCH 3/5 v3] drm/bridge: adv7511: Enable HPD interrupts to support hotplug and improve monitor detection John Stultz
2017-01-03 19:41 ` [PATCH 4/5 v3] drm/bridge: adv7511: Rework adv7511_power_on/off() so they can be reused internally John Stultz
2017-01-03 19:41   ` John Stultz
2017-01-16 15:50   ` Laurent Pinchart
2017-01-16 15:50     ` Laurent Pinchart
2017-01-03 19:41 ` [PATCH 5/5 v3] drm/bridge: adv7511: Reuse __adv7511_power_on/off() when probing EDID John Stultz
2017-01-16 16:03   ` Laurent Pinchart
2017-01-16 16:03     ` Laurent Pinchart
2017-01-16 20:14     ` John Stultz
2017-01-16 20:14       ` John Stultz
2017-01-16 22:25       ` Laurent Pinchart
2017-01-16 22:25         ` Laurent Pinchart
2017-01-16 23:16         ` [RFC][PATCH] drm/bridge: adv7511: Re-write the i2c address as it may have been lost John Stultz
2017-01-16 23:16           ` John Stultz
2017-01-16 23:36           ` Laurent Pinchart
2017-01-16 23:39             ` John Stultz
2017-01-11  8:48 ` [PATCH 0/5 v3] adv7511 EDID probing improvements Archit Taneja
2017-01-12  0:06   ` John Stultz
2017-01-12  0:06     ` John Stultz
2017-01-12  4:22     ` Archit Taneja
2017-01-16 15:57 ` Laurent Pinchart [this message]
2017-01-16 15:57   ` Laurent Pinchart

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=9649749.TAVrhOzo15@avalon \
    --to=laurent.pinchart@ideasonboard.com \
    --cc=dri-devel@lists.freedesktop.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=wsa+renesas@sang-engineering.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.