RE: 4430SDP boot failure

[Santosh Shilimkar <santosh.shilimkar@ti.com>]

> -----Original Message-----
> From: Russell King - ARM Linux [mailto:linux@arm.linux.org.uk]
> Sent: Friday, January 07, 2011 9:54 PM
> To: Santosh Shilimkar
> Cc: linux-omap@vger.kernel.org; Tony Lindgren
> Subject: Re: 4430SDP boot failure
>
> On Fri, Jan 07, 2011 at 07:56:34PM +0530, Santosh Shilimkar wrote:
> > > -----Original Message-----
> > > From: Russell King - ARM Linux [mailto:linux@arm.linux.org.uk]
> > > Sent: Friday, January 07, 2011 7:55 PM
> > > To: Santosh Shilimkar
> > > Cc: linux-omap@vger.kernel.org; Tony Lindgren
> > > Subject: Re: 4430SDP boot failure
> > >
> > > On Fri, Jan 07, 2011 at 06:39:06PM +0530, Santosh Shilimkar
> wrote:
> > > > Have sent you latest bootloaders and full bootlog on my ES1.0
> > > > OMAP4430SDP. 2.6.37 just boots fine for me.
> > > >
> > > > Low level debug as you reported seems to be broken though.
> > >
> > > Many thanks, the new mlo and uboot gets dhcp/tftp working nicely
> on
> > > the board - which should ease the debugging problem as it no
> longer
> > > requires anything but the reset button pressed to test a new
> kernel.
> >
> > Glad to hear that.
>
> Right, next couple of problems.
>
> udev isn't creating the ttyO* nodes for whatever reason on my fs -
> does
> anyone know what device major/minor numbers these end up with?  It
> seems
> they're dynamically assigned.
>
Right now don't have access to my board so can't check this.

> There's also something fishy going on with networking (if I
> configure
> PNP IP, I get an IP:
>
> ks8851 spi1.0: message enable is 0
> ks8851 spi1.0: eth0: revision 0, MAC 1a:6a:b1:02:1d:90, IRQ 194
> IP-Config: Got DHCP answer from 0.0.0.0, my address is 192.168.0.144
> IP-Config: Complete:
>      device=eth0, addr=192.168.0.144, mask=255.255.255.0,
> gw=192.168.0.1,
>      host=192.168.0.144, domain=arm.linux.org.uk, nis-domain=(none),
>      bootserver=0.0.0.0, rootserver=0.0.0.0, rootpath=
>
> but the board doesn't respond to that IP address.  Meanwhile the
> DHCP
> server shows:
>
> 	DHCPDISCOVER from 1a:6a:b1:02:1d:90 via eth0
>
> in its log, and the ethernet address appears to be random for each
> boot.
> Obviously, as I can't log into the board via any means, it's nigh on
> impossible to work out what's actually going on.

DHCP seems to work for me without any issues.