Re: [PATCH] omap4: Fix ULPI PHY init for ES1.0 SDP (Re: 4430SDP boot failure)

[Tony Lindgren <tony@atomide.com>]

* Russell King - ARM Linux <linux@arm.linux.org.uk> [110113 01:15]:
> On Thu, Jan 13, 2011 at 02:22:06PM +0530, Anand Gadiyar wrote:
> > Tony Lindgren wrote:
> > >  	/* Power on the ULPI PHY */
> > > -	if (gpio_is_valid(OMAP4SDP_MDM_PWR_EN_GPIO)) {
> > > -		/* FIXME: Assumes pad is already muxed for GPIO mode */
> > > -		gpio_request(OMAP4SDP_MDM_PWR_EN_GPIO, "USBB1 PHY
> > VMDM_3V3");
> > > +	status = gpio_request(OMAP4SDP_MDM_PWR_EN_GPIO, "USBB1 PHY
> > VMDM_3V3");
> > > +	if (status)
> > > +		pr_err("%s: Could not get USBB1 PHY GPIO\n");
> > 
> > Tony,
> > 
> > This throws up a build warning as there's no parameter corresponding to
> > the %s. Showed up in linux-next as of today.

Oops, sorry, will fix.
 
> It's pretty obvious that the above is wrong, and the compiler would
> have caught it with a warning when building it.  Was the above patch
> not build-tested before it was committed?

Sure, boot tested it but missed the warning though.
 
> Given the very sorry state of OMAP in mainline at present, I'm surprised
> that this kind of stuff is still going on...

At least I boot test the patches I send..

Regards,

Tony