From: Peter Ujfalusi <peter.ujfalusi@ti.com>
To: Mark Brown <broonie@kernel.org>,
Liam Girdwood <lgirdwood@gmail.com>,
dmurphy@ti.com
Cc: alsa-devel@alsa-project.org
Subject: [PATCH v2 17/23] ASoC: tas2552: Add support for word length configuration
Date: Thu, 4 Jun 2015 16:04:29 +0300 [thread overview]
Message-ID: <1433423075-14142-18-git-send-email-peter.ujfalusi@ti.com> (raw)
In-Reply-To: <1433423075-14142-1-git-send-email-peter.ujfalusi@ti.com>
Configure the word length based on the params_width of the stream.
Also configure the clock per frame value which is used when tas2552 is bus
master.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
---
sound/soc/codecs/tas2552.c | 38 ++++++++++++++++++++++++++++++++++++++
sound/soc/codecs/tas2552.h | 10 ++++++++++
2 files changed, 48 insertions(+)
diff --git a/sound/soc/codecs/tas2552.c b/sound/soc/codecs/tas2552.c
index 9c081344bd90..13b435f9a9b1 100644
--- a/sound/soc/codecs/tas2552.c
+++ b/sound/soc/codecs/tas2552.c
@@ -166,7 +166,45 @@ static int tas2552_hw_params(struct snd_pcm_substream *substream,
struct tas2552_data *tas2552 = dev_get_drvdata(codec->dev);
int sample_rate, pll_clk;
int d;
+ int cpf;
u8 p, j;
+ u8 ser_ctrl1_reg;
+
+ switch (params_width(params)) {
+ case 16:
+ ser_ctrl1_reg = TAS2552_WORDLENGTH_16BIT;
+ cpf = 32 + tas2552->tdm_delay;
+ break;
+ case 20:
+ ser_ctrl1_reg = TAS2552_WORDLENGTH_20BIT;
+ cpf = 64 + tas2552->tdm_delay;
+ break;
+ case 24:
+ ser_ctrl1_reg = TAS2552_WORDLENGTH_24BIT;
+ cpf = 64 + tas2552->tdm_delay;
+ break;
+ case 32:
+ ser_ctrl1_reg = TAS2552_WORDLENGTH_32BIT;
+ cpf = 64 + tas2552->tdm_delay;
+ break;
+ default:
+ dev_err(codec->dev, "Not supported sample size: %d\n",
+ params_width(params));
+ return -EINVAL;
+ }
+
+ if (cpf <= 32)
+ ser_ctrl1_reg |= TAS2552_CLKSPERFRAME_32;
+ else if (cpf <= 64)
+ ser_ctrl1_reg |= TAS2552_CLKSPERFRAME_64;
+ else if (cpf <= 128)
+ ser_ctrl1_reg |= TAS2552_CLKSPERFRAME_128;
+ else
+ ser_ctrl1_reg |= TAS2552_CLKSPERFRAME_256;
+
+ snd_soc_update_bits(codec, TAS2552_SER_CTRL_1,
+ TAS2552_WORDLENGTH_MASK | TAS2552_CLKSPERFRAME_MASK,
+ ser_ctrl1_reg);
if (!tas2552->pll_clkin)
return -EINVAL;
diff --git a/sound/soc/codecs/tas2552.h b/sound/soc/codecs/tas2552.h
index 5bdc7eaaddea..de0ab0d27520 100644
--- a/sound/soc/codecs/tas2552.h
+++ b/sound/soc/codecs/tas2552.h
@@ -66,11 +66,21 @@
#define TAS2552_SDOUT_TRISTATE (1 << 2)
/* Serial Interface Control Register Masks */
+#define TAS2552_WORDLENGTH_16BIT (0x0 << 0)
+#define TAS2552_WORDLENGTH_20BIT (0x1 << 0)
+#define TAS2552_WORDLENGTH_24BIT (0x2 << 0)
+#define TAS2552_WORDLENGTH_32BIT (0x3 << 0)
+#define TAS2552_WORDLENGTH_MASK TAS2552_WORDLENGTH_32BIT
#define TAS2552_DATAFORMAT_I2S (0x0 << 2)
#define TAS2552_DATAFORMAT_DSP (0x1 << 2)
#define TAS2552_DATAFORMAT_RIGHT_J (0x2 << 2)
#define TAS2552_DATAFORMAT_LEFT_J (0x3 << 2)
#define TAS2552_DATAFORMAT_MASK TAS2552_DATAFORMAT_LEFT_J
+#define TAS2552_CLKSPERFRAME_32 (0x0 << 4)
+#define TAS2552_CLKSPERFRAME_64 (0x1 << 4)
+#define TAS2552_CLKSPERFRAME_128 (0x2 << 4)
+#define TAS2552_CLKSPERFRAME_256 (0x3 << 4)
+#define TAS2552_CLKSPERFRAME_MASK TAS2552_CLKSPERFRAME_256
#define TAS2552_BCLKDIR (1 << 6)
#define TAS2552_WCLKDIR (1 << 7)
--
2.4.2
next prev parent reply other threads:[~2015-06-04 13:05 UTC|newest]
Thread overview: 34+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-06-04 13:04 [PATCH v2 00/23] ASoC: tas2552: Fixes, cleanups and improvements Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 01/23] ASoC: tas2552: Make the enable-gpio really optional Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 02/23] ASoC: tas2552: Fix kernel crash when the codec is loaded but not part of a card Peter Ujfalusi
2015-06-04 16:25 ` Mark Brown
2015-06-05 6:57 ` Peter Ujfalusi
2015-06-04 16:50 ` Mark Brown
2015-06-04 13:04 ` [PATCH v2 03/23] ASoC: tas2552: Fix kernel crash caused by wrong kcontrol entry Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 04/23] ASoC: tas2552: Correct PDM configuration register bit definitions Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 05/23] ASoC: tas2552: Correct CFG1 " Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 06/23] ASoC: tas2552: Simplify the tas2552_mute function Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 07/23] ASoC: tas2552: Simplify and reverse the functionality of tas2552_sw_shutdown Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 08/23] ASoC: tas2552: Rename mclk parameter to pll_clkin to match with the datasheet Peter Ujfalusi
2015-06-04 16:51 ` Mark Brown
2015-06-04 13:04 ` [PATCH v2 09/23] DT/sound: bindings header file for tas2552 codec Peter Ujfalusi
2015-06-05 17:54 ` Mark Brown
2015-06-04 13:04 ` [PATCH v2 10/23] ASoC: tas2552: Add support for pll and pdm source clock selection Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 11/23] ASoC: tas2552: Correct dai format support Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 12/23] ASoC: tas2552: Correct and clean up data format and BCLK/WCLK direction Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 13/23] ASoC: tas2552: Add TDM support Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 14/23] ASoC: tas2552: Clean up the Digital - Analog DAPM route definition Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 15/23] ASoC: tas2552: Correct the Speaker Driver Playback Volume (PGA_GAIN) Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 16/23] ASoC: tas2552: Implement startup/stop sequence as per TRM Peter Ujfalusi
2015-06-04 13:04 ` Peter Ujfalusi [this message]
2015-06-04 13:04 ` [PATCH v2 18/23] ASoC: tas2552: Configure the WCLK frequency based on the stream Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 19/23] ASoC: tas2552: Correct the PLL configuration Peter Ujfalusi
2015-06-05 6:53 ` Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 20/23] ASoC: tas2552: Add control for selecting DIN source Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 21/23] ASoC: tas2552: Correct Output Data register usage Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 22/23] ASoC: tas2552: Correct Boost Auto-Pass Through Control " Peter Ujfalusi
2015-06-04 13:04 ` [PATCH v2 23/23] ASoC: tas2552: Code, define alignment changes for uniformity Peter Ujfalusi
2015-06-05 17:53 ` [PATCH v2 00/23] ASoC: tas2552: Fixes, cleanups and improvements Mark Brown
2015-06-08 7:52 ` Peter Ujfalusi
2015-06-08 9:24 ` Mark Brown
2015-06-08 9:54 ` Peter Ujfalusi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1433423075-14142-18-git-send-email-peter.ujfalusi@ti.com \
--to=peter.ujfalusi@ti.com \
--cc=alsa-devel@alsa-project.org \
--cc=broonie@kernel.org \
--cc=dmurphy@ti.com \
--cc=lgirdwood@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox