[PATCH v2 02/47] crypto/dpaa2_sec: fix FLE pool leak on sec FD build failure

[Prashant Gupta <prashant.gupta_3@nxp.com>]

From: Gagandeep Singh <g.singh@nxp.com>

When build_sec_fd fails at index loop inside the enqueue burst loops,
the previously built FD entries (indices 0..loop-1) were never freed.
The cleanup loop iterated in the wrong direction, starting at the
failed index and going up to frames_to_send, which are entries that
were never built. This caused silent FLE pool exhaustion, after which
every subsequent build_sec_fd returned -ENOMEM, enqueue_burst
returned 0 indefinitely, and the crypto-perf test hung.

Fix both dpaa2_sec_enqueue_burst and dpaa2_sec_enqueue_burst_ordered
by clamping frames_to_send to loop + 1 and iterating from 0 to
free all allocated FLE buffers including the failed entry.

Fixes: 623326dded3a ("crypto/dpaa2_sec: introduce poll mode driver")
Cc: stable@dpdk.org
Signed-off-by: Gagandeep Singh <g.singh@nxp.com>
---
 drivers/crypto/dpaa2_sec/dpaa2_sec_dpseci.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/crypto/dpaa2_sec/dpaa2_sec_dpseci.c b/drivers/crypto/dpaa2_sec/dpaa2_sec_dpseci.c
index 96c2e56ff5..e710b4fbd3 100644
--- a/drivers/crypto/dpaa2_sec/dpaa2_sec_dpseci.c
+++ b/drivers/crypto/dpaa2_sec/dpaa2_sec_dpseci.c
@@ -1553,6 +1553,9 @@ dpaa2_sec_enqueue_burst(void *qp, struct rte_crypto_op **ops,
 			ret = build_sec_fd(*ops, &fd_arr[loop], bpid, dpaa2_qp);
 			if (ret) {
 				DPAA2_SEC_DP_DEBUG("FD build failed");
+				frames_to_send = loop + 1;
+				for (loop = 0; loop < frames_to_send; loop++)
+					free_fle(&fd_arr[loop], dpaa2_qp);
 				goto skip_tx;
 			}
 			ops++;
@@ -1912,6 +1915,9 @@ dpaa2_sec_enqueue_burst_ordered(void *qp, struct rte_crypto_op **ops,
 			ret = build_sec_fd(*ops, &fd_arr[loop], bpid, dpaa2_qp);
 			if (ret) {
 				DPAA2_SEC_DP_DEBUG("FD build failed");
+				frames_to_send = loop + 1;
+				for (loop = 0; loop < frames_to_send; loop++)
+					free_fle(&fd_arr[loop], dpaa2_qp);
 				goto skip_tx;
 			}
 			ops++;
-- 
2.43.0