Re: [Intel-gfx] [RFC 1/6] drm/i915: Iterate over pipe and skip the disabled one

From: Anshuman Gupta <anshuman.gupta@intel.com>
To: Jani Nikula <jani.nikula@intel.com>
Cc: intel-gfx@lists.freedesktop.org
Subject: Re: [Intel-gfx] [RFC 1/6] drm/i915: Iterate over pipe and skip the disabled one
Date: Fri, 24 Jan 2020 17:29:51 +0530	[thread overview]
Message-ID: <20200124115951.GC24118@intel.com> (raw)
In-Reply-To: <87wo9icmi2.fsf@intel.com>

On 2020-01-23 at 15:48:05 +0200, Jani Nikula wrote:
> On Thu, 23 Jan 2020, Anshuman Gupta <anshuman.gupta@intel.com> wrote:
> > It should not be assumed that a disabled display pipe will be
> > always last the pipe.
> > for_each_pipe() should iterate over I915_MAX_PIPES and check
> > for the disabled pipe and skip that pipe so that it should not
> > initialize the intel crtc for any disabled pipes.
> >
> > Few compilation error needed to handle accordingly due to
> > change in for_each_pipe() macro.
> 
> Really? Please paste.
It is dangling-else warning at couple of places.
drivers/gpu/drm/i915/i915_irq.c:1861:5: error: suggest explicit braces to avoid ambiguous ‘else’ [-Werror=dangling-else]
 1861 |  if (pch_iir & SDE_FDI_MASK)
drivers/gpu/drm/i915/i915_irq.c:1944:5: error: suggest explicit braces to avoid ambiguous ‘else’ [-Werror=dangling-else]
1944 |  if (pch_iir & SDE_FDI_MASK_CPT)
> 
> >
> > Cc: Ville Syrjälä <ville.syrjala@linux.intel.com>
> > Signed-off-by: Anshuman Gupta <anshuman.gupta@intel.com>
> > ---
> >  drivers/gpu/drm/i915/display/intel_display.h | 5 +++--
> >  drivers/gpu/drm/i915/i915_irq.c              | 6 ++++--
> >  2 files changed, 7 insertions(+), 4 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/i915/display/intel_display.h b/drivers/gpu/drm/i915/display/intel_display.h
> > index 028aab728514..47813a50add4 100644
> > --- a/drivers/gpu/drm/i915/display/intel_display.h
> > +++ b/drivers/gpu/drm/i915/display/intel_display.h
> > @@ -312,10 +312,11 @@ enum phy_fia {
> >  };
> >  
> >  #define for_each_pipe(__dev_priv, __p) \
> > -	for ((__p) = 0; (__p) < INTEL_NUM_PIPES(__dev_priv); (__p)++)
> > +	for ((__p) = 0; (__p) < I915_MAX_PIPES; (__p)++) \
> 
> Originally I was envisioning using for_each_set_bit() from bitops.h for
> this. It's probably more efficient, however I'm not sure if efficiency
> matters much here. The ugly part is that for_each_set_bit() requires an
> explicit cast to unsigned long *.
> 
> Perhaps this is just as well, it's not wrong, and can always be updated
> later.
> 
> > +		for_each_if((INTEL_INFO(__dev_priv)->pipe_mask) & BIT(__p))
> >  
> >  #define for_each_pipe_masked(__dev_priv, __p, __mask) \
> > -	for ((__p) = 0; (__p) < INTEL_NUM_PIPES(__dev_priv); (__p)++) \
> > +	for_each_pipe(__dev_priv, __p) \
> >  		for_each_if((__mask) & BIT(__p))
> >  
> >  #define for_each_cpu_transcoder_masked(__dev_priv, __t, __mask) \
> > diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c
> > index 94cb25ac504d..22ecd5bc407e 100644
> > --- a/drivers/gpu/drm/i915/i915_irq.c
> > +++ b/drivers/gpu/drm/i915/i915_irq.c
> > @@ -1735,11 +1735,12 @@ static void ibx_irq_handler(struct drm_i915_private *dev_priv, u32 pch_iir)
> >  	if (pch_iir & SDE_POISON)
> >  		DRM_ERROR("PCH poison interrupt\n");
> >  
> > -	if (pch_iir & SDE_FDI_MASK)
> > +	if (pch_iir & SDE_FDI_MASK) {
> >  		for_each_pipe(dev_priv, pipe)
> >  			DRM_DEBUG_DRIVER("  pipe %c FDI IIR: 0x%08x\n",
> >  					 pipe_name(pipe),
> >  					 I915_READ(FDI_RX_IIR(pipe)));
> > +	}
> 
> Are the brace changes really needed? This is what the for_each_if hack
> is supposed to tackle.
IMHO it was dangling-else compilation, warning that requires braces.
please correct me if i am wrong.
Thanks,
Anshuman
> 
> >  
> >  	if (pch_iir & (SDE_TRANSB_CRC_DONE | SDE_TRANSA_CRC_DONE))
> >  		DRM_DEBUG_DRIVER("PCH transcoder CRC done interrupt\n");
> > @@ -1818,11 +1819,12 @@ static void cpt_irq_handler(struct drm_i915_private *dev_priv, u32 pch_iir)
> >  	if (pch_iir & SDE_AUDIO_CP_CHG_CPT)
> >  		DRM_DEBUG_DRIVER("Audio CP change interrupt\n");
> >  
> > -	if (pch_iir & SDE_FDI_MASK_CPT)
> > +	if (pch_iir & SDE_FDI_MASK_CPT) {
> >  		for_each_pipe(dev_priv, pipe)
> >  			DRM_DEBUG_DRIVER("  pipe %c FDI IIR: 0x%08x\n",
> >  					 pipe_name(pipe),
> >  					 I915_READ(FDI_RX_IIR(pipe)));
> > +	}
> >  
> >  	if (pch_iir & SDE_ERROR_CPT)
> >  		cpt_serr_int_handler(dev_priv);
> 
> -- 
> Jani Nikula, Intel Open Source Graphics Center
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx