Re: [PATCH 3/3] arm64: dts: rockchip: Add Radxa E24C

[Jonas Karlman <jonas@kwiboo.se>]

Hi Andrew,

On 7/27/2025 6:15 PM, Andrew Lunn wrote:
>> +&gmac1 {
>> +	clock_in_out = "output";
>> +	phy-mode = "rgmii-id";
>> +	phy-supply = <&avdd_rtl8367rb>;
>> +	pinctrl-names = "default";
>> +	pinctrl-0 = <&rgmii_miim>, <&rgmii_tx_bus2>, <&rgmii_rx_bus2>,
>> +		    <&rgmii_rgmii_clk>, <&rgmii_rgmii_bus>, <&gmac1_rstn_l>;
>> +	status = "okay";
>> +
>> +	fixed-link {
>> +		speed = <1000>;
>> +		full-duplex;
>> +	};
> 
> A fixed-link without an obvious reason gets me asking questions...
> 
> The schematic indicates there is a realtek 6387 switch on the other
> end. rtl8365mb.c seems to support this. Is there a reason you did not
> include this now?

Sorry, this was mentioned in the cover letter, and patches to enable use
of the switch is incoming in a separate series very shortly.

"""
This also leaves out describing the RTL8367RB-VB switch as support for
the switch requires dt-binding and/or driver changes to make it work,
something that will be handled in a separate follow-up series.
"""

Basically the dt-bindings prevents describing a mdio child node, yet the
driver requires it. I have prepared a patch that relaxes the driver to
make it all work and it should be on the list shortly.

Regards,
Jonas

> 
> 	Andrew