Re: [PATCH 3/8] i3c: mipi-i3c-hci: Add a quirk for 64-bit DMA addressing

[Frank Li <Frank.li@oss.nxp.com>]

On Tue, Sep 01, 2026 at 07:35:30PM +0800, Billy Tsai wrote:
> The HCI ring base registers are 64 bits wide by specification, but not
> every implementation wires the upper half, so the driver leaves the
> platform device at the default 32-bit DMA mask unless told otherwise.
> ASPEED platforms place all of DRAM above the 32-bit boundary
> (0x4_00000000), so under the default mask every dma_alloc_coherent()
> call for the DMA rings fails.
>
> Add HCI_QUIRK_DMA_64BIT for controllers whose DMA engine drives the
> full address width, and declare a 64-bit streaming and coherent DMA
> mask for them before the rings are allocated.
>
> Signed-off-by: Billy Tsai <billy_tsai@aspeedtech.com>
> Assisted-by: Claude:claude-fable-5
> ---
>  drivers/i3c/master/mipi-i3c-hci/core.c | 7 +++++++
>  drivers/i3c/master/mipi-i3c-hci/hci.h  | 1 +
>  2 files changed, 8 insertions(+)
>
> diff --git a/drivers/i3c/master/mipi-i3c-hci/core.c b/drivers/i3c/master/mipi-i3c-hci/core.c
> index a624e3c40484..c03c3a9cbe4f 100644
> --- a/drivers/i3c/master/mipi-i3c-hci/core.c
> +++ b/drivers/i3c/master/mipi-i3c-hci/core.c
> @@ -10,6 +10,7 @@
>  #include <linux/bitfield.h>
>  #include <linux/clk.h>
>  #include <linux/device.h>
> +#include <linux/dma-mapping.h>
>  #include <linux/errno.h>
>  #include <linux/i3c/master.h>
>  #include <linux/interrupt.h>
> @@ -1167,6 +1168,12 @@ static int i3c_hci_probe(struct platform_device *pdev)
>  	hci->quirks = (unsigned long)device_get_match_data(&pdev->dev);
>  	if (!hci->quirks && platform_get_device_id(pdev))
>  		hci->quirks = platform_get_device_id(pdev)->driver_data;
> +	if (hci->quirks & HCI_QUIRK_DMA_64BIT) {
> +		ret = dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(64));

dma_set_mask_and_coherent() never return fail when bit mask >= 32

	if (hci->quirks & HCI_QUIRK_DMA_64BIT)
		dma_set_mask_and_coherent(&pdev->dev, DMA_BIT_MASK(64));

Frank

> +		if (ret)
> +			return dev_err_probe(&pdev->dev, ret,
> +					     "cannot set DMA mask\n");
> +	}
>
>  	ret = devm_clk_bulk_get_all_enabled(&pdev->dev, &clks);
>  	if (ret < 0)
> diff --git a/drivers/i3c/master/mipi-i3c-hci/hci.h b/drivers/i3c/master/mipi-i3c-hci/hci.h
> index f50fc1e22a85..2110f806a53c 100644
> --- a/drivers/i3c/master/mipi-i3c-hci/hci.h
> +++ b/drivers/i3c/master/mipi-i3c-hci/hci.h
> @@ -178,6 +178,7 @@ struct i3c_hci_dev_data {
>  #define HCI_QUIRK_DMA_ABORT_REQUIRES_PIO_RESET	BIT(8)  /* Do PIO queue SW resets after DMA abort */
>  #define HCI_QUIRK_DMA_REQUIRES_HC_ABORT		BIT(9)  /* Use HC_CONTROL ABORT to abort DMA */
>  #define HCI_QUIRK_DAT_INDEX_IS_ADDR	BIT(10)  /* DAT entries are indexed by device address */
> +#define HCI_QUIRK_DMA_64BIT		BIT(11)  /* Controller DMA supports 64-bit addressing */
>
>  /* global functions */
>  void mipi_i3c_hci_resume(struct i3c_hci *hci);
>
> --
> 2.34.1
>