Re: [PATCH v2 2/4] arm64: dts: qcom: shikra-cqm-evk: Enable display and add ili7807s panel

[Arpit Saini <arpit.saini@oss.qualcomm.com>]

Hi Konrad,

On 7/6/2026 3:33 PM, Konrad Dybcio wrote:
> On 7/6/26 8:04 AM, Nabige Aala wrote:
>> From: Arpit Saini <arpit.saini@oss.qualcomm.com>
>>
>> Enable the Qualcomm Shikra MDSS display subsystem on the Shikra CQM EVK
>> board and add the DLC0697 MIPI DSI display panel node. Pin pm4125_l5
>> to 1.232V with regulator-allow-set-load for DSI PHY PLL stability.
>>
>> Signed-off-by: Arpit Saini <arpit.saini@oss.qualcomm.com>
>> Signed-off-by: Nabige Aala <nabige.aala@oss.qualcomm.com>
>> ---
> [...]
>
>> +	panel_bl_en: panel-bl-en-state {
>> +		pins = "gpio91";
>> +		function = "gpio";
>> +		drive-strength = <2>;
>> +		bias-disable;
>> +		output-high;
>> +	};
>> +
>> +	panel_bl_en_suspend: panel-bl-en-suspend-state {
>> +		pins = "gpio91";
>> +		function = "gpio";
>> +		drive-strength = <2>;
>> +		bias-pull-down;
>> +		output-low;
>> +	};
> output-foo isn't necessary, the panel driver will assert it as
> necessary
>
> Konrad

Ack, thanks for pointing out.

Arpit