[PATCH V3 0/9] Refactor phy powerup sequence

[Nitin Rawat <quic_nitirawa@quicinc.com>]

In Current code regulators enable, clks enable, calibrating UFS PHY,
start_serdes and polling PCS_ready_status are part of phy_power_on.

UFS PHY registers are retained after power collapse, meaning calibrating
UFS PHY, start_serdes and polling PCS_ready_status can be done only when
hba is powered_on, and not needed every time when phy_power_on is called
during resume. Hence keep the code which enables PHY's regulators & clks
in phy_power_on and move the rest steps into phy_calibrate function.

Since phy_power_on is separated out from phy calibrate, make separate calls
to phy_power_on and phy_calibrate calls from ufs qcom driver.

Also for better power saving, remove the phy_power_on/off calls from
resume/suspend path and put them to ufs_qcom_setup_clocks, so that
PHY's regulators & clks can be turned on/off along with UFS's clocks.

This patch series is tested on SM8550 QRD, SM8650 MTP , SM8750 MTP.

Changes in v3:
1. Addresed neil and bjorn comment to align the order of the patch to
   maintain the bisectability compliance within the patch.
2. Addressed neil comment to move qmp_ufs_get_phy_reset() in a separate
   patch, inline qmp_ufs_com_init() inline.

Changes in v2:
1. Addressed vinod koul and manivannan comment to split the phy patch
   into multiple patches.
2. Addressed vinod's comment to reuse SW_PWRDN instead of creating
   new macros SW_PWRUP in phy-qcom-qmp-ufs.c.
3. Addressed Konrad's comment to optimize mutex lock in ufs-qcom.c
4. Addressed konrad and Manivannan comment to clean debug print in
   ufs-qcom.c

Nitin Rawat (9):
  scsi: ufs: qcom: add a new phy calibrate API call
  phy: qcom-qmp-ufs: Rename qmp_ufs_enable and qmp_ufs_power_on
  phy: qcom-qmp-ufs: Refactor phy_power_on and phy_calibrate callbacks
  phy: qcom-qmp-ufs: Refactor UFS PHY reset
  phy: qcom-qmp-ufs: Remove qmp_ufs_com_init()
  phy: qcom-qmp-ufs: Refactor qmp_ufs_exit callback.
  scsi: ufs: qcom : Refactor phy_power_on/off calls
  scsi: ufs: qcom : Introduce phy_power_on/off wrapper function
  scsi: ufs: qcom: Prevent calling phy_exit before phy_init

 drivers/phy/qualcomm/phy-qcom-qmp-ufs.c | 145 ++++++++----------------
 drivers/ufs/host/ufs-qcom.c             |  96 ++++++++++------
 drivers/ufs/host/ufs-qcom.h             |   4 +
 3 files changed, 111 insertions(+), 134 deletions(-)

--
2.48.1


-- 
linux-phy mailing list
linux-phy@lists.infradead.org
https://lists.infradead.org/mailman/listinfo/linux-phy