Re: [PATCH 0/7] Minor cleanup for thermal gov power allocator

[Lukasz Luba <lukasz.luba@arm.com>]

On 11/28/23 15:17, Rafael J. Wysocki wrote:
> On Fri, Nov 24, 2023 at 8:44 AM Lukasz Luba <lukasz.luba@arm.com> wrote:
>>
>>
>>
>> On 11/23/23 19:50, Rafael J. Wysocki wrote:
>>> Hi Lukasz,
>>>
>>> On Thu, Nov 23, 2023 at 4:19 PM Lukasz Luba <lukasz.luba@arm.com> wrote:
>>>>
>>>> Hi Rafael,
>>>>
>>>> Gentle ping
>>>>
>>>> On 10/26/23 13:22, Lukasz Luba wrote:
>>>>>
>>>>>
>>>>> On 10/26/23 09:54, Rafael J. Wysocki wrote:
>>>>>> On Wed, Oct 25, 2023 at 9:21 PM Lukasz Luba <lukasz.luba@arm.com> wrote:
>>>>>>>
>>>>>>> Hi all,
>>>>>>>
>>>>>>> The patch set does some small clean up for Intelligent Power Allocator.
>>>>>>> Those changes are not expected to alter the general functionality.
>>>>>>> They just
>>>>>>> improve the code reading. Only patch 3/7 might improve the use case for
>>>>>>> binding the governor to thermal zone (very unlikely in real products,
>>>>>>> but
>>>>>>> it's needed for correctness).
>>>>>>>
>>>>>>> The changes are based on top of current PM thermal branch, so with the
>>>>>>> new trip points.
>>>>>>>
>>>>>>> Regards,
>>>>>>> Lukasz
>>>>>>>
>>>>>>> Lukasz Luba (7):
>>>>>>>      thermal: gov_power_allocator: Rename trip_max_desired_temperature
>>>>>>>      thermal: gov_power_allocator: Setup trip points earlier
>>>>>>>      thermal: gov_power_allocator: Check the cooling devices only for
>>>>>>>        trip_max
>>>>>>>      thermal: gov_power_allocator: Rearrange the order of variables
>>>>>>>      thermal: gov_power_allocator: Use shorter variable when possible
>>>>>>>      thermal: gov_power_allocator: Remove unneeded local variables
>>>>>>>      thermal: gov_power_allocator: Clean needed variables at the beginning
>>>>>>>
>>>>>>>     drivers/thermal/gov_power_allocator.c | 123 ++++++++++++++------------
>>>>>>>     1 file changed, 64 insertions(+), 59 deletions(-)
>>>>>>>
>>>>>>> --
>>>>>>
>>>>>> The series looks good to me overall, but I'd prefer to make these
>>>>>> changes in the 6.8 cycle, because the 6.7 merge window is around the
>>>>>> corner and there is quite a bit of thermal material in this cycle
>>>>>> already.
>>>>>
>>>>> Thanks for having a look! Yes, I agree, we can wait after the
>>>>> merge window. It just have to be cleaned one day a bit and I postponed
>>>>> this a few times, so no rush ;)
>>>>
>>>> I've seen you've created the new pm/thermal. Could you consider to take
>>>> those in, please?
>>>
>>> Sure, I'll get to them presumably tomorrow and if not then early next week.
>>
>> OK, thank you Rafael!
> 
> I've queued up the whole lot for 6.8 and in the process I've edited
> all of the changelogs and some subjects for clarity and English
> grammar improvements.

Thank you and I really appreciate the improvements!