Netdev List
 help / color / mirror / Atom feed
* [PATCH net v3 00/10] net: au1000: Bug fixes
@ 2026-11-17 19:32 Florian Fainelli
  2026-11-17 19:32 ` [PATCH net v3 01/10] net: au1000: recycle RX descriptors on allocation failure Florian Fainelli
                   ` (10 more replies)
  0 siblings, 11 replies; 12+ messages in thread
From: Florian Fainelli @ 2026-11-17 19:32 UTC (permalink / raw)
  To: netdev
  Cc: Florian Fainelli, Andrew Lunn, David S. Miller, Eric Dumazet,
	Jakub Kicinski, Paolo Abeni, Heiner Kallweit, Russell King,
	Jijie Shao, Simon Horman, Runyu Xiao, David Yang,
	Herbert Valerio Riedel, Danny Kukawka, Mugunthan V N,
	Sebastian Hesselbarth, open list, Manuel Lauss

This series fixes RX descriptor recycling, receive filtering, MDIO error
reporting, TX ring synchronization, MAC/PHY lifecycle ordering, and TX
bounce-buffer bounds in the Au1xxx Ethernet driver. It also adds the
LAN83C183 PHY resume delay needed for MII clock recovery on the MTX-1.

Changes in v3:
- Drop the no-platform-data MAC-address patch: in-tree platform devices
  always supply platform data, so this is defensive hardening rather
  than a fix for an in-tree configuration.
- Drop the buffer descriptor free-list insertion patch: the affected
  list is only rebuilt during teardown and is never consumed again.
  The series now contains 10 patches instead of 12.
- Distinguish MDIO write-completion timeouts from pre-write busy
  timeouts in the diagnostic message.
- Clarify that the LAN83C183 recovery-delay patch and the following
  au1000 MAC/PHY sequencing patch are both required to fix MTX-1 reopen.
  Keep the PHY patch first so its delay is available to the MAC fix.
- Remove the unreachable initialization-error branch and PHY rollback
  from au1000_open(). Correct the commit message to distinguish the new
  synchronous PHY resume from the existing initialization-before-
  phy_start() ordering, and reconcile the reset comments.
- Expand the TX bounds-check commit message to cover plain AF_PACKET
  sendmsg(), PACKET_TX_RING, and oversized software-GSO segments.
- Rebuild the kernel and root filesystem and repeat MTX-1 regression
  testing after the review changes.

Changes in v2:
- Rebase onto net.
- Reset the MAC after PHY/MDIO teardown, and avoid MAC control accesses
  when its clock is already disabled.
- Use sleepable polling for MDIO write completion.
- Advance tx_tail when submission reclaims a completed TX descriptor,
  and consume transmitted skbs outside the lock with an IRQ-safe helper.
- Restore receive filtering before enabling RX, with the address-list
  and device locks held to keep the programmed filter consistent.
- Resume the PHY synchronously before MAC initialization, clear cached
  link state on open, and use acknowledged link/duplex state under the
  device lock. Place the LAN83C183 recovery-delay patch before this fix.
- Add a TX length check to prevent overflowing the DMA bounce buffer.

Testing:
The current series was rebuilt with Buildroot and tested on a Meshcube
MTX-1, using the Alchemy PROM Ethernet-address lifetime fix as a separate
boot prerequisite. That prerequisite is not included in this series.
All 11 boot-smoke checks passed, including 15 down/up cycles across
normal, promiscuous and all-multicast modes, removal/rebind after an
opened/closed interface and a never-opened interface, and connectivity
recovery. No kernel findings were reported. The final 10-packet ping
lost one reply; a subsequent 100-packet test had zero loss. The cause of
the isolated loss was not established.

These hardware tests cover boot and Ethernet lifecycle behavior; full
AF_PACKET overflow triggers and fault injection were not exercised.

Sashiko AI review identified issues addressed in the revisions. OpenAI
Codex assisted source analysis, code and changelog revisions, patch
consolidation, and regression testing.

Florian Fainelli (10):
  net: au1000: recycle RX descriptors on allocation failure
  net: au1000: clear all-multicast mode when restoring hash filtering
  net: au1000: disconnect the PHY before freeing the MDIO bus
  net: au1000: report MDIO transaction timeouts
  net: au1000: serialize TX completion with packet submission
  net: au1000: restore receive filtering before enabling RX
  net: au1000: restore RX buffer addresses when restarting the MAC
  net: phy: smsc: wait for LAN83C183 power-down recovery
  net: au1000: keep the MAC stopped until the PHY link is ready
  net: au1000: reject frames larger than the TX bounce buffer

 drivers/net/ethernet/amd/au1000_eth.c | 145 +++++++++++++++++++-------
 drivers/net/phy/Kconfig               |   2 +-
 drivers/net/phy/smsc.c                |  26 +++++
 3 files changed, 133 insertions(+), 40 deletions(-)


base-commit: 145480b28ca82e9fae789427cc4569e596515a32
-- 
2.53.0


^ permalink raw reply	[flat|nested] 12+ messages in thread

end of thread, other threads:[~2026-11-17 19:38 UTC | newest]

Thread overview: 12+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2026-11-17 19:32 [PATCH net v3 00/10] net: au1000: Bug fixes Florian Fainelli
2026-11-17 19:32 ` [PATCH net v3 01/10] net: au1000: recycle RX descriptors on allocation failure Florian Fainelli
2026-11-17 19:32 ` [PATCH net v3 02/10] net: au1000: clear all-multicast mode when restoring hash filtering Florian Fainelli
2026-11-17 19:32 ` [PATCH net v3 03/10] net: au1000: disconnect the PHY before freeing the MDIO bus Florian Fainelli
2026-11-17 19:32 ` [PATCH net v3 04/10] net: au1000: report MDIO transaction timeouts Florian Fainelli
2026-11-17 19:32 ` [PATCH net v3 05/10] net: au1000: serialize TX completion with packet submission Florian Fainelli
2026-11-17 19:32 ` [PATCH net v3 06/10] net: au1000: restore receive filtering before enabling RX Florian Fainelli
2026-11-17 19:32 ` [PATCH net v3 07/10] net: au1000: restore RX buffer addresses when restarting the MAC Florian Fainelli
2026-11-17 19:32 ` [PATCH net v3 08/10] net: phy: smsc: wait for LAN83C183 power-down recovery Florian Fainelli
2026-11-17 19:32 ` [PATCH net v3 09/10] net: au1000: keep the MAC stopped until the PHY link is ready Florian Fainelli
2026-11-17 19:32 ` [PATCH net v3 10/10] net: au1000: reject frames larger than the TX bounce buffer Florian Fainelli
2026-11-17 19:38 ` [PATCH net v3 00/10] net: au1000: Bug fixes netdev-bot+sinfo

This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox