[U-Boot] [PATCH 1/2 V2] arm926: Flush the data cache before disabling it.

[Marek Vasut <marek.vasut@gmail.com>]

> On Wed Jan 11, 2012 at 11:47:27AM +0100, Marek Vasut wrote:
> > > On Tue Jan 10, 2012 at 09:07:58PM +0100, Marek Vasut wrote:
> > > > > The current implementation invalidates the cache instead of
> > > > > flushing it. This causes problems on platforms where the
> > > > > spl/u-boot is already loaded to the RAM, with caches enabled by a
> > > > > first stage bootloader.
> > > > 
> > > > What platforms are affected?
> > > > 
> > >   It is causing a problem on the hawkboard, where the spl is loaded
> > >   directly to the RAM by a rom bootloader. We did not see this earlier
> > >   since cpu_init_crit was not getting called due to
> > >   CONFIG_SKIP_LOWLEVEL_INIT.
> > > 
> > > -sughosh
> > 
> > I see ... why don't you directly load U-Boot to DRAM then ?
> 
>   The rom bootloader(rbl) uses a different ecc layout from the one
>   used by the davinci nand driver(u-boot and linux).

Can't you just tell the driver to use the correct ecc layout when flashing then?

>   Using rbl to load
>   the u-boot to dram would mean that i have to use the TI's external
>   flashing utility every time i upgrade u-boot.

Not really, just adjust the NAND driver to handle this special case.

>   Also, i would not be
>   able to flash u-boot from the kernel.

I think it's possible though, right?

M
> 
> -sughosh