[U-Boot] [PATCH 1/2 V2] arm926: Flush the data cache before disabling it.

[Sughosh Ganu <urwithsughosh@gmail.com>]

hi Heiko,

On Fri Jan 13, 2012 at 04:06:22PM +0100, Heiko Schocher wrote:

<snip>

> 
> >>        mcr     p15, 0, r0, c8, c7, 0   /* flush v4 TLB */
> >>
> >>        /*
> >>         * disable MMU stuff and caches
> >>         */
> >>        mrc     p15, 0, r0, c1, c0, 0
> >> -       bic     r0, r0, #0x00002300     /* clear bits 13, 9:8 (--V- --RS) */
> >> +       bic     r0, r0, #0x00000300     /* clear bits 9:8 ( --RS) */
> > 
> > Ok, I read your comment above.
> 
> Hmm.. what should we do with the V-Bit? Is it OK not to clear it for all
> cases?

  The V bit gets set to the value of VINITHI input pin on reset, which
  is the default value. This setting clears the V bit by default,
  which shifts the vector table to 0x0. Certain SoC's(e.g omap-l138)
  don't have any valid memory at 0x0. Hence i think this setting
  should not be made here, but on a SOC level.

> 
> Tested this patch on the cam_enc_4xx and enbw_cmc board, works fine
> on that boards.
> 
> > 
> >>        bic     r0, r0, #0x00000087     /* clear bits 7, 2:0 (B--- -CAM) */
> >>        orr     r0, r0, #0x00000002     /* set bit 2 (A) Align */
> >>        orr     r0, r0, #0x00001000     /* set bit 12 (I) I-Cache */
> > 
> > Although this is not changed in your patch, the last line makes me
> > wonder. The comment says "disable MMU stuff and cached", but actually
> > the last line sets bit 12 (I), which means that I-Cache gets enabled
> > according to [1].
> 
> Yes, the last line enables the I-Cache. So we should at least add a
> better comment here.

  I will fix the other comments too in the next version.

-sughosh