[U-Boot] [PATCH 1/2 V2] arm926: Flush the data cache before disabling it.

[Sughosh Ganu <urwithsughosh@gmail.com>]

On Wed Jan 11, 2012 at 02:52:44PM +0100, Marek Vasut wrote:

> > >   Changing the ecc layout for a single board, hmm not sure. Using a
> > >   spl instead does me no harm whatsoever -- I don't need to update the
> > >   spl frequently in any case, and then can use the nand driver as is.
> > 
> > And how do you replace the SPL?
> > 
> > Either way, I think the correct approach is to allow the driver to handle
> > the SPL update too.
> 
> Or rather -- to be able to load u-boot directly. It seems to be more correct 
> solution. The SPL you're using is just a workaround and also you need to TI 
> flasher to replace it, right ?

  Yes, using the spl is a workaround, and like i mentioned in my
  previous mail, i thought having the spl was not a problem on the
  hawkboard. I had thought putting a new oob layout in the common
  davinci nand driver for a single board to be not a clean fix
  either. More so, given the fact that we don't have any control over
  rbl -- so if rbl changes it's layout for any subsequent board, we'd
  have to add that as well to the nand driver, and both in u-boot as
  well as the kernel.

  I guess the cleanest solution would have been for the rbl to have
  used the same layout as the one used by u-boot and linux.

  Btw, can you please review this change, that this patch
  fixes. ACK/NAK?

-sughosh