Re: [lm-sensors] [PATCH 1/3] Add support for GMT G72/G763 PWM fan controller

[Andrew Lunn <andrew@lunn.ch>]

Hi Arnaud

> +static DEVICE_ATTR(pwm1, S_IWUSR | S_IRUGO, get_pwm, set_pwm);
> +static DEVICE_ATTR(pwm1_polarity, S_IWUSR | S_IRUGO,
> +		   get_pwm_polarity, set_pwm_polarity);
> +static DEVICE_ATTR(pwm1_mode, S_IWUSR | S_IRUGO,
> +		   get_pwm_mode, set_pwm_mode);
> +static DEVICE_ATTR(pwm1_enable, S_IWUSR | S_IRUGO,
> +		   get_speed_control_mode, set_speed_control_mode);
> +static DEVICE_ATTR(pwm1_freq, S_IWUSR | S_IRUGO,
> +		   get_pwm_freq, set_pwm_freq);
> +
> +static DEVICE_ATTR(fan1_input, S_IRUGO, get_fan_rpm, NULL);
> +static DEVICE_ATTR(fan1_alarm, S_IRUGO, get_fan_ooc, NULL);
> +static DEVICE_ATTR(fan1_alarm_detection, S_IWUSR | S_IRUGO,
> +		   get_fan_ooc_detection, set_fan_ooc_detection);
> +static DEVICE_ATTR(fan1_fault, S_IRUGO, get_fan_failure, NULL);
> +static DEVICE_ATTR(fan1_fault_detection, S_IWUSR | S_IRUGO,
> +		   get_fan_failure_detection, set_fan_failure_detection);
> +static DEVICE_ATTR(fan1_target, S_IWUSR | S_IRUGO,
> +		   get_fan_target, set_fan_target);
> +static DEVICE_ATTR(fan1_pulses, S_IWUSR | S_IRUGO,
> +		   get_fan_pulses, set_fan_pulses);
> +static DEVICE_ATTR(fan1_div, S_IWUSR | S_IRUGO,
> +		   get_fan_clk_div, set_fan_clk_div);
> +static DEVICE_ATTR(fan1_gear_mode, S_IWUSR | S_IRUGO,
> +		   get_fan_gear_mode, set_fan_gear_mode);
> +static DEVICE_ATTR(fan1_startup_voltage, S_IWUSR | S_IRUGO,
> +		   get_fan_startup_voltage, set_fan_startup_voltage);

It is normal to use SENSOR_ATTR, not DEVICE_ATTR. Take a look at the
existing fan drivers.

I also think a lot of these are not needed. They are fixed properties
of the board and cannot change dynamically. They are set once using DT
and user space does not need to care.

	 Andrew

_______________________________________________
lm-sensors mailing list
lm-sensors@lm-sensors.org
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors