[PATCH v6 01/87] usb: host: re-import xhci-ext-caps.h from kernel v6.16

[Anders Roxell <anders.roxell@linaro.org>]

From: Jerome Forissier <jerome.forissier@linaro.org>

Import drivers/usb/host/xhci-ext-caps.h from Linux v6.16. The file
is needed by the updated DWC3 code.

Signed-off-by: Jerome Forissier <jerome.forissier@linaro.org>
Signed-off-by: Jens Wiklander <jens.wiklander@linaro.org>
Signed-off-by: Anders Roxell <anders.roxell@linaro.org>
Reviewed-by: Mattijs Korpershoek <mkorpershoek@kernel.org>
---
 drivers/usb/host/xhci-ext-caps.h | 158 +++++++++++++++++++++++++++++++
 1 file changed, 158 insertions(+)
 create mode 100644 drivers/usb/host/xhci-ext-caps.h

diff --git a/drivers/usb/host/xhci-ext-caps.h b/drivers/usb/host/xhci-ext-caps.h
new file mode 100644
index 000000000000..c93bcf4f4f7d
--- /dev/null
+++ b/drivers/usb/host/xhci-ext-caps.h
@@ -0,0 +1,158 @@
+/* SPDX-License-Identifier: GPL-2.0 */
+/* Imported from Linux v6.16 */
+/*
+ * xHCI host controller driver
+ *
+ * Copyright (C) 2008 Intel Corp.
+ *
+ * Author: Sarah Sharp
+ * Some code borrowed from the Linux EHCI driver.
+ */
+
+/* HC should halt within 16 ms, but use 32 ms as some hosts take longer */
+#define XHCI_MAX_HALT_USEC	(32 * 1000)
+/* HC not running - set to 1 when run/stop bit is cleared. */
+#define XHCI_STS_HALT		(1<<0)
+
+/* HCCPARAMS offset from PCI base address */
+#define XHCI_HCC_PARAMS_OFFSET	0x10
+/* HCCPARAMS contains the first extended capability pointer */
+#define XHCI_HCC_EXT_CAPS(p)	(((p)>>16)&0xffff)
+
+/* Command and Status registers offset from the Operational Registers address */
+#define XHCI_CMD_OFFSET		0x00
+#define XHCI_STS_OFFSET		0x04
+
+#define XHCI_MAX_EXT_CAPS		50
+
+/* Capability Register */
+/* bits 7:0 - how long is the Capabilities register */
+#define XHCI_HC_LENGTH(p)	(((p)>>00)&0x00ff)
+
+/* Extended capability register fields */
+#define XHCI_EXT_CAPS_ID(p)	(((p)>>0)&0xff)
+#define XHCI_EXT_CAPS_NEXT(p)	(((p)>>8)&0xff)
+#define	XHCI_EXT_CAPS_VAL(p)	((p)>>16)
+/* Extended capability IDs - ID 0 reserved */
+#define XHCI_EXT_CAPS_LEGACY	1
+#define XHCI_EXT_CAPS_PROTOCOL	2
+#define XHCI_EXT_CAPS_PM	3
+#define XHCI_EXT_CAPS_VIRT	4
+#define XHCI_EXT_CAPS_ROUTE	5
+/* IDs 6-9 reserved */
+#define XHCI_EXT_CAPS_DEBUG	10
+/* Vendor caps */
+#define XHCI_EXT_CAPS_VENDOR_INTEL	192
+#define XHCI_EXT_CAPS_INTEL_SPR_SHADOW	206
+/* USB Legacy Support Capability - section 7.1.1 */
+#define XHCI_HC_BIOS_OWNED	(1 << 16)
+#define XHCI_HC_OS_OWNED	(1 << 24)
+
+/* USB Legacy Support Capability - section 7.1.1 */
+/* Add this offset, plus the value of xECP in HCCPARAMS to the base address */
+#define XHCI_LEGACY_SUPPORT_OFFSET	(0x00)
+
+/* USB Legacy Support Control and Status Register  - section 7.1.2 */
+/* Add this offset, plus the value of xECP in HCCPARAMS to the base address */
+#define XHCI_LEGACY_CONTROL_OFFSET	(0x04)
+/* bits 1:3, 5:12, and 17:19 need to be preserved; bits 21:28 should be zero */
+#define	XHCI_LEGACY_DISABLE_SMI		((0x7 << 1) + (0xff << 5) + (0x7 << 17))
+#define XHCI_LEGACY_SMI_EVENTS		(0x7 << 29)
+
+/* USB 2.0 xHCI 0.96 L1C capability - section 7.2.2.1.3.2 */
+#define XHCI_L1C               (1 << 16)
+
+/* USB 2.0 xHCI 1.0 hardware LMP capability - section 7.2.2.1.3.2 */
+#define XHCI_HLC               (1 << 19)
+#define XHCI_BLC               (1 << 20)
+
+/* Intel SPR shadow capability */
+#define XHCI_INTEL_SPR_ESS_PORT_OFFSET  0x8ac4	/* SuperSpeed port control */
+#define XHCI_INTEL_SPR_TUNEN	BIT(4)		/* Tunnel mode enabled */
+
+/* command register values to disable interrupts and halt the HC */
+/* start/stop HC execution - do not write unless HC is halted*/
+#define XHCI_CMD_RUN		(1 << 0)
+/* Event Interrupt Enable - get irq when EINT bit is set in USBSTS register */
+#define XHCI_CMD_EIE		(1 << 2)
+/* Host System Error Interrupt Enable - get irq when HSEIE bit set in USBSTS */
+#define XHCI_CMD_HSEIE		(1 << 3)
+/* Enable Wrap Event - '1' means xHC generates an event when MFINDEX wraps. */
+#define XHCI_CMD_EWE		(1 << 10)
+
+#define XHCI_IRQS		(XHCI_CMD_EIE | XHCI_CMD_HSEIE | XHCI_CMD_EWE)
+
+/* true: Controller Not Ready to accept doorbell or op reg writes after reset */
+#define XHCI_STS_CNR		(1 << 11)
+
+/**
+ * struct xhci_protocol_caps
+ * @revision:		major revision, minor revision, capability ID,
+ *			and next capability pointer.
+ * @name_string:	Four ASCII characters to say which spec this xHC
+ *			follows, typically "USB ".
+ * @port_info:		Port offset, count, and protocol-defined information.
+ */
+struct xhci_protocol_caps {
+	u32	revision;
+	u32	name_string;
+	u32	port_info;
+};
+
+#define	XHCI_EXT_PORT_MAJOR(x)	(((x) >> 24) & 0xff)
+#define	XHCI_EXT_PORT_MINOR(x)	(((x) >> 16) & 0xff)
+#define	XHCI_EXT_PORT_PSIC(x)	(((x) >> 28) & 0x0f)
+#define	XHCI_EXT_PORT_OFF(x)	((x) & 0xff)
+#define	XHCI_EXT_PORT_COUNT(x)	(((x) >> 8) & 0xff)
+
+#define	XHCI_EXT_PORT_PSIV(x)	(((x) >> 0) & 0x0f)
+#define	XHCI_EXT_PORT_PSIE(x)	(((x) >> 4) & 0x03)
+#define	XHCI_EXT_PORT_PLT(x)	(((x) >> 6) & 0x03)
+#define	XHCI_EXT_PORT_PFD(x)	(((x) >> 8) & 0x01)
+#define	XHCI_EXT_PORT_LP(x)	(((x) >> 14) & 0x03)
+#define	XHCI_EXT_PORT_PSIM(x)	(((x) >> 16) & 0xffff)
+
+#include <linux/io.h>
+
+/**
+ * Find the offset of the extended capabilities with capability ID id.
+ *
+ * @base	PCI MMIO registers base address.
+ * @start	address at which to start looking, (0 or HCC_PARAMS to start at
+ *		beginning of list)
+ * @id		Extended capability ID to search for, or 0 for the next
+ *		capability
+ *
+ * Returns the offset of the next matching extended capability structure.
+ * Some capabilities can occur several times, e.g., the XHCI_EXT_CAPS_PROTOCOL,
+ * and this provides a way to find them all.
+ */
+
+static inline int xhci_find_next_ext_cap(void __iomem *base, u32 start, int id)
+{
+	u32 val;
+	u32 next;
+	u32 offset;
+
+	offset = start;
+	if (!start || start == XHCI_HCC_PARAMS_OFFSET) {
+		val = readl(base + XHCI_HCC_PARAMS_OFFSET);
+		if (val == ~0)
+			return 0;
+		offset = XHCI_HCC_EXT_CAPS(val) << 2;
+		if (!offset)
+			return 0;
+	}
+	do {
+		val = readl(base + offset);
+		if (val == ~0)
+			return 0;
+		if (offset != start && (id == 0 || XHCI_EXT_CAPS_ID(val) == id))
+			return offset;
+
+		next = XHCI_EXT_CAPS_NEXT(val);
+		offset += next << 2;
+	} while (next);
+
+	return 0;
+}
-- 
2.53.0