From: Rodrigo Vivi <rodrigo.vivi@intel.com>
To: intel-gfx@lists.freedesktop.org
Subject: [PATCH 4/6] drm/i915/cnp: Backlight support for CNP.
Date: Fri, 2 Jun 2017 13:06:42 -0700 [thread overview]
Message-ID: <1496434004-29812-4-git-send-email-rodrigo.vivi@intel.com> (raw)
In-Reply-To: <1496434004-29812-1-git-send-email-rodrigo.vivi@intel.com>
Split out BXT and CNP's setup_backlight(),enable_backlight(),
disable_backlight() and hz_to_pwm() into
two separate functions instead of reusing BXT function.
Reuse set_backlight() and get_backlight() since they have
no reference to the utility pin.
v2: Reuse BXT functions with controller 0 instead of
redefining it. (Jani).
Use dev_priv->rawclk_freq instead of getting the value
from SFUSE_STRAP.
v3: Avoid setup backligh controller along with hooks and
fully reuse hooks setup as suggested by Jani.
v4: Clean up commit message.
v5: Implement per PCH instead per platform.
v6: Introduce a new function for CNP.(Jani and Ville)
v7: Squash the all CNP Backlight support patches into a
single patch. (Jani)
v8: Correct indentation, remove unneeded blank lines and
correct mail address (Jani).
v9: Remove unused enum pipe. (by CI)
v10: Remove comment mentioning SFUSE_STRAP in a part of
the code that we don't use it. (Jani)
Make controller = 0 since current CNP has only one
controller and put a comment mentioning why we
reuse the BXT definitions and are keeping the
controller = 0. (DK)
v11: Remove spurious line. (DK)
Reviewed-by: Jani Nikula <jani.nikula@intel.com>
Suggested-by: Jani Nikula <jani.nikula@intel.com>
Suggested-by: Ville Syrjala <ville.syrjala@intel.com>
Cc: Ville Syrjala <ville.syrjala@linux.intel.com>
Cc: Jani Nikula <jani.nikula@intel.com>
Signed-off-by: Anusha Srivatsa <anusha.srivatsa@intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>
---
drivers/gpu/drm/i915/intel_panel.c | 96 ++++++++++++++++++++++++++++++++++++++
1 file changed, 96 insertions(+)
diff --git a/drivers/gpu/drm/i915/intel_panel.c b/drivers/gpu/drm/i915/intel_panel.c
index c8103f8..4114cb3 100644
--- a/drivers/gpu/drm/i915/intel_panel.c
+++ b/drivers/gpu/drm/i915/intel_panel.c
@@ -796,6 +796,19 @@ static void bxt_disable_backlight(struct intel_connector *connector)
}
}
+static void cnp_disable_backlight(struct intel_connector *connector)
+{
+ struct drm_i915_private *dev_priv = to_i915(connector->base.dev);
+ struct intel_panel *panel = &connector->panel;
+ u32 tmp;
+
+ intel_panel_actually_set_backlight(connector, 0);
+
+ tmp = I915_READ(BXT_BLC_PWM_CTL(panel->backlight.controller));
+ I915_WRITE(BXT_BLC_PWM_CTL(panel->backlight.controller),
+ tmp & ~BXT_BLC_PWM_ENABLE);
+}
+
static void pwm_disable_backlight(struct intel_connector *connector)
{
struct intel_panel *panel = &connector->panel;
@@ -1086,6 +1099,35 @@ static void bxt_enable_backlight(struct intel_connector *connector)
pwm_ctl | BXT_BLC_PWM_ENABLE);
}
+static void cnp_enable_backlight(struct intel_connector *connector)
+{
+ struct drm_i915_private *dev_priv = to_i915(connector->base.dev);
+ struct intel_panel *panel = &connector->panel;
+ u32 pwm_ctl;
+
+ pwm_ctl = I915_READ(BXT_BLC_PWM_CTL(panel->backlight.controller));
+ if (pwm_ctl & BXT_BLC_PWM_ENABLE) {
+ DRM_DEBUG_KMS("backlight already enabled\n");
+ pwm_ctl &= ~BXT_BLC_PWM_ENABLE;
+ I915_WRITE(BXT_BLC_PWM_CTL(panel->backlight.controller),
+ pwm_ctl);
+ }
+
+ I915_WRITE(BXT_BLC_PWM_FREQ(panel->backlight.controller),
+ panel->backlight.max);
+
+ intel_panel_actually_set_backlight(connector, panel->backlight.level);
+
+ pwm_ctl = 0;
+ if (panel->backlight.active_low_pwm)
+ pwm_ctl |= BXT_BLC_PWM_POLARITY;
+
+ I915_WRITE(BXT_BLC_PWM_CTL(panel->backlight.controller), pwm_ctl);
+ POSTING_READ(BXT_BLC_PWM_CTL(panel->backlight.controller));
+ I915_WRITE(BXT_BLC_PWM_CTL(panel->backlight.controller),
+ pwm_ctl | BXT_BLC_PWM_ENABLE);
+}
+
static void pwm_enable_backlight(struct intel_connector *connector)
{
struct intel_panel *panel = &connector->panel;
@@ -1250,6 +1292,17 @@ void intel_backlight_device_unregister(struct intel_connector *connector)
#endif /* CONFIG_BACKLIGHT_CLASS_DEVICE */
/*
+ * CNP: PWM clock frequency is 19.2 MHz or 24 MHz.
+ * PWM increment = 1
+ */
+static u32 cnp_hz_to_pwm(struct intel_connector *connector, u32 pwm_freq_hz)
+{
+ struct drm_i915_private *dev_priv = to_i915(connector->base.dev);
+
+ return DIV_ROUND_CLOSEST(KHz(dev_priv->rawclk_freq), pwm_freq_hz);
+}
+
+/*
* BXT: PWM clock frequency = 19.2 MHz.
*/
static u32 bxt_hz_to_pwm(struct intel_connector *connector, u32 pwm_freq_hz)
@@ -1644,6 +1697,42 @@ static int vlv_setup_backlight(struct intel_connector *connector, enum pipe pipe
return 0;
}
+static int
+cnp_setup_backlight(struct intel_connector *connector, enum pipe unused)
+{
+ struct drm_i915_private *dev_priv = to_i915(connector->base.dev);
+ struct intel_panel *panel = &connector->panel;
+ u32 pwm_ctl, val;
+
+ /*
+ * CNP has the BXT implementation of backlight, but with only
+ * one controller. Future platforms could have multiple controllers
+ * so let's make this extensible and prepared for the future.
+ */
+ panel->backlight.controller = 0;
+
+ pwm_ctl = I915_READ(BXT_BLC_PWM_CTL(panel->backlight.controller));
+
+ panel->backlight.active_low_pwm = pwm_ctl & BXT_BLC_PWM_POLARITY;
+ panel->backlight.max =
+ I915_READ(BXT_BLC_PWM_FREQ(panel->backlight.controller));
+
+ if (!panel->backlight.max)
+ panel->backlight.max = get_backlight_max_vbt(connector);
+
+ if (!panel->backlight.max)
+ return -ENODEV;
+
+ val = bxt_get_backlight(connector);
+ val = intel_panel_compute_brightness(connector, val);
+ panel->backlight.level = clamp(val, panel->backlight.min,
+ panel->backlight.max);
+
+ panel->backlight.enabled = pwm_ctl & BXT_BLC_PWM_ENABLE;
+
+ return 0;
+}
+
static int pwm_setup_backlight(struct intel_connector *connector,
enum pipe pipe)
{
@@ -1760,6 +1849,13 @@ void intel_panel_destroy_backlight(struct drm_connector *connector)
panel->backlight.set = bxt_set_backlight;
panel->backlight.get = bxt_get_backlight;
panel->backlight.hz_to_pwm = bxt_hz_to_pwm;
+ } else if (HAS_PCH_CNP(dev_priv)) {
+ panel->backlight.setup = cnp_setup_backlight;
+ panel->backlight.enable = cnp_enable_backlight;
+ panel->backlight.disable = cnp_disable_backlight;
+ panel->backlight.set = bxt_set_backlight;
+ panel->backlight.get = bxt_get_backlight;
+ panel->backlight.hz_to_pwm = cnp_hz_to_pwm;
} else if (HAS_PCH_LPT(dev_priv) || HAS_PCH_SPT(dev_priv) ||
HAS_PCH_KBP(dev_priv)) {
panel->backlight.setup = lpt_setup_backlight;
--
1.9.1
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
next prev parent reply other threads:[~2017-06-02 20:06 UTC|newest]
Thread overview: 19+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-06-02 20:06 [PATCH 1/6] drm/i915/cnp: Introduce Cannonpoint PCH Rodrigo Vivi
2017-06-02 20:06 ` [PATCH 2/6] drm/i915/cnp: Add PCI ID for Cannonpoint LP PCH Rodrigo Vivi
2017-06-02 20:06 ` [PATCH 3/6] drm/i915/cnp: Get/set proper Raw clock frequency on CNP Rodrigo Vivi
2017-06-02 20:06 ` Rodrigo Vivi [this message]
2017-06-02 20:06 ` [PATCH 5/6] drm/i915/cnp: add CNP gmbus support Rodrigo Vivi
2017-06-02 20:06 ` [PATCH 6/6] drm/i915/cnp: Panel Power sequence changes for CNP PCH Rodrigo Vivi
2017-06-03 3:15 ` Rodrigo Vivi
2017-06-02 20:21 ` ✓ Fi.CI.BAT: success for series starting with [1/6] drm/i915/cnp: Introduce Cannonpoint PCH Patchwork
-- strict thread matches above, loose matches on Subject: below --
2017-06-01 22:33 [PATCH 1/6] " Rodrigo Vivi
2017-06-01 22:33 ` [PATCH 4/6] drm/i915/cnp: Backlight support for CNP Rodrigo Vivi
2017-06-01 22:43 ` Pandiyan, Dhinakaran
2017-06-01 0:23 [PATCH 1/6] drm/i915/cnp: Introduce Cannonpoint PCH Rodrigo Vivi
2017-06-01 0:23 ` [PATCH 4/6] drm/i915/cnp: Backlight support for CNP Rodrigo Vivi
2017-06-01 14:01 ` Jani Nikula
2017-05-30 22:11 [PATCH 1/6] drm/i915/cnp: Introduce Cannonpoint PCH Rodrigo Vivi
2017-05-30 22:11 ` [PATCH 4/6] drm/i915/cnp: Backlight support for CNP Rodrigo Vivi
2017-05-30 21:53 [PATCH 1/6] drm/i915/cnp: Introduce Cannonpoint PCH Rodrigo Vivi
2017-05-30 21:53 ` [PATCH 4/6] drm/i915/cnp: Backlight support for CNP Rodrigo Vivi
2017-05-31 5:57 ` kbuild test robot
2017-05-09 19:16 [PATCH 0/6] Cannonpoint Enabling Patches Anusha Srivatsa
2017-05-09 19:16 ` [PATCH 4/6] drm/i915/cnp: Backlight support for CNP Anusha Srivatsa
2017-05-08 23:44 [PATCH 0/6] Cannonpoint Enabling Patches Anusha Srivatsa
2017-05-08 23:45 ` [PATCH 4/6] drm/i915/cnp: Backlight support for CNP Anusha Srivatsa
2017-05-09 0:10 ` Pandiyan, Dhinakaran
2017-05-09 0:11 ` Srivatsa, Anusha
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1496434004-29812-4-git-send-email-rodrigo.vivi@intel.com \
--to=rodrigo.vivi@intel.com \
--cc=intel-gfx@lists.freedesktop.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox