Intel-GFX Archive on lore.kernel.org
 help / color / mirror / Atom feed
From: Imre Deak <imre.deak@intel.com>
To: intel-gfx@lists.freedesktop.org
Cc: "Ville Syrjälä" <ville.syrjala@linux.intel.com>
Subject: [PATCH v5 1/8] drm/i915/dp: Flush modeset commits during connector detection
Date: Fri, 25 Oct 2024 19:02:52 +0300	[thread overview]
Message-ID: <20241025160259.3088727-2-imre.deak@intel.com> (raw)
In-Reply-To: <20241025160259.3088727-1-imre.deak@intel.com>

Make sure that a DP connector detection doesn't happen in parallel
with an ongoing modeset on the connector. The reasons for this are:

- Besides reading the capabilities, EDID etc. the detection may change
  the state of the sink (via the AUX bus), for instance by setting the
  LTTPR mode or the source OUI (the latter introduced by an upcoming
  patch). It's better to avoid such changes affecting an onging modeset
  in any way.

- During a modeset's link training any access to DPCD registers, besides
  the registers used for link training should be avoided, at least in
  the LTTPR non-transparent and transparent link training modes.

  Such asynchronous accesses - besides connector detection - can also
  happen via the AUX device node for instance, for those a parallel
  modeset will have to be avoided in a similar way to the change in this
  patch. (A topic for a follow-up change.)

- The source OUI written to an eDP sink is valid only while the panel
  power is enabled. A modeset on eDP will enable/disable the panel power
  synchronously; this should be prevented in the middle of the connector
  detection, to ensure a consistent sink state (which depends on the
  source OUI) for the whole duration of detection. The panel power could
  still get disabled during detection after an idle period (1 sec), this
  will be prevented by the next patch.

v2: (Ville)
- s/wait_for_crtc_hw_done/wait_for_connector_hw_done
- Get drm_device using an intel_display instead of drm_i915_private ptr.

Reviewed-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
Signed-off-by: Imre Deak <imre.deak@intel.com>
---
 drivers/gpu/drm/i915/display/intel_dp.c     | 27 ++++++++++++++++++---
 drivers/gpu/drm/i915/display/intel_dp.h     |  1 +
 drivers/gpu/drm/i915/display/intel_dp_mst.c |  2 ++
 3 files changed, 26 insertions(+), 4 deletions(-)

diff --git a/drivers/gpu/drm/i915/display/intel_dp.c b/drivers/gpu/drm/i915/display/intel_dp.c
index 7e29619ba0400..d2019c9ef8e91 100644
--- a/drivers/gpu/drm/i915/display/intel_dp.c
+++ b/drivers/gpu/drm/i915/display/intel_dp.c
@@ -5036,6 +5036,21 @@ bool intel_dp_has_connector(struct intel_dp *intel_dp,
 	return false;
 }
 
+static void wait_for_connector_hw_done(const struct drm_connector_state *conn_state)
+{
+	struct intel_connector *connector = to_intel_connector(conn_state->connector);
+	struct intel_display *display = to_intel_display(connector);
+
+	drm_modeset_lock_assert_held(&display->drm->mode_config.connection_mutex);
+
+	if (!conn_state->commit)
+		return;
+
+	drm_WARN_ON(display->drm,
+		    !wait_for_completion_timeout(&conn_state->commit->hw_done,
+						 msecs_to_jiffies(5000)));
+}
+
 int intel_dp_get_active_pipes(struct intel_dp *intel_dp,
 			      struct drm_modeset_acquire_ctx *ctx,
 			      u8 *pipe_mask)
@@ -5072,10 +5087,7 @@ int intel_dp_get_active_pipes(struct intel_dp *intel_dp,
 		if (!crtc_state->hw.active)
 			continue;
 
-		if (conn_state->commit)
-			drm_WARN_ON(&i915->drm,
-				    !wait_for_completion_timeout(&conn_state->commit->hw_done,
-								 msecs_to_jiffies(5000)));
+		wait_for_connector_hw_done(conn_state);
 
 		*pipe_mask |= BIT(crtc->pipe);
 	}
@@ -5084,6 +5096,11 @@ int intel_dp_get_active_pipes(struct intel_dp *intel_dp,
 	return ret;
 }
 
+void intel_dp_flush_connector_commits(struct intel_connector *connector)
+{
+	wait_for_connector_hw_done(connector->base.state);
+}
+
 static bool intel_dp_is_connected(struct intel_dp *intel_dp)
 {
 	struct intel_connector *connector = intel_dp->attached_connector;
@@ -5597,6 +5614,8 @@ intel_dp_detect(struct drm_connector *connector,
 	if (!intel_display_driver_check_access(dev_priv))
 		return connector->status;
 
+	intel_dp_flush_connector_commits(intel_connector);
+
 	/* Can't disconnect eDP */
 	if (intel_dp_is_edp(intel_dp))
 		status = edp_detect(intel_dp);
diff --git a/drivers/gpu/drm/i915/display/intel_dp.h b/drivers/gpu/drm/i915/display/intel_dp.h
index 60baf4072dc9d..4efb9605a50e0 100644
--- a/drivers/gpu/drm/i915/display/intel_dp.h
+++ b/drivers/gpu/drm/i915/display/intel_dp.h
@@ -54,6 +54,7 @@ void intel_dp_set_link_params(struct intel_dp *intel_dp,
 int intel_dp_get_active_pipes(struct intel_dp *intel_dp,
 			      struct drm_modeset_acquire_ctx *ctx,
 			      u8 *pipe_mask);
+void intel_dp_flush_connector_commits(struct intel_connector *connector);
 void intel_dp_link_check(struct intel_encoder *encoder);
 void intel_dp_check_link_state(struct intel_dp *intel_dp);
 void intel_dp_set_power(struct intel_dp *intel_dp, u8 mode);
diff --git a/drivers/gpu/drm/i915/display/intel_dp_mst.c b/drivers/gpu/drm/i915/display/intel_dp_mst.c
index 1a2ff3e1cb68f..5bba078c00d89 100644
--- a/drivers/gpu/drm/i915/display/intel_dp_mst.c
+++ b/drivers/gpu/drm/i915/display/intel_dp_mst.c
@@ -1573,6 +1573,8 @@ intel_dp_mst_detect(struct drm_connector *connector,
 	if (!intel_display_driver_check_access(i915))
 		return connector->status;
 
+	intel_dp_flush_connector_commits(intel_connector);
+
 	return drm_dp_mst_detect_port(connector, ctx, &intel_dp->mst_mgr,
 				      intel_connector->port);
 }
-- 
2.44.2


  reply	other threads:[~2024-10-25 16:02 UTC|newest]

Thread overview: 14+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2024-10-25 16:02 [PATCH v5 0/8] drm/i915: Write source OUI for non-eDP sinks Imre Deak
2024-10-25 16:02 ` Imre Deak [this message]
2024-10-25 16:02 ` [PATCH v5 2/8] drm/i915/dp: Ensure panel power remains enabled during connector detection Imre Deak
2024-10-25 16:02 ` [PATCH v5 3/8] drm/i915/dp: Initialize the source OUI write timestamp always Imre Deak
2024-10-25 16:02 ` [PATCH v5 4/8] drm/i915/dp: Track source OUI validity explicitly Imre Deak
2024-10-25 16:02 ` [PATCH v5 5/8] drm/i915/dp: Reuse intel_dp_detect_dsc_caps() for eDP Imre Deak
2024-10-25 16:02 ` [PATCH v5 6/8] drm/i915/dp: Write the source OUI for eDP before detecting sink capabilities Imre Deak
2024-10-25 16:02 ` [PATCH v5 7/8] drm/i915/dp: Write the source OUI during connector detection Imre Deak
2024-10-25 16:02 ` [PATCH v5 8/8] drm/i915/dp: Write the source OUI for non-eDP sinks as well Imre Deak
2024-10-28 15:20   ` Ville Syrjälä
2024-10-25 16:52 ` ✗ Fi.CI.SPARSE: warning for drm/i915: Write source OUI for non-eDP sinks (rev4) Patchwork
2024-10-25 17:09 ` ✓ Fi.CI.BAT: success " Patchwork
2024-10-25 22:12 ` ✗ Fi.CI.IGT: failure " Patchwork
2024-10-31 17:00   ` Imre Deak

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20241025160259.3088727-2-imre.deak@intel.com \
    --to=imre.deak@intel.com \
    --cc=intel-gfx@lists.freedesktop.org \
    --cc=ville.syrjala@linux.intel.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox