Re: [PATCH 05/14] drm/i915: Perform manual conversions for crtc uapi/hw split

[Maarten Lankhorst <maarten.lankhorst@linux.intel.com>]

Op 17-10-2019 om 15:20 schreef Maarten Lankhorst:
> intel_get_load_detect_pipe() needs to set uapi active,
> uapi enable is set by the call to drm_atomic_set_mode_for_crtc(),
> so we can remove it.
>
> intel_pipe_config_compare() needs to look at hw state, but I didn't
> change spatch to look at it. It's easy enough to do manually.
>
> intel_atomic_check() definitely needs to check for uapi enable,
> otherwise intel_modeset_pipe_config cannot copy uapi state to hw.
>
> Signed-off-by: Maarten Lankhorst <maarten.lankhorst@linux.intel.com>
> ---
>  drivers/gpu/drm/i915/display/intel_display.c | 42 ++++++++++----------
>  1 file changed, 21 insertions(+), 21 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/display/intel_display.c b/drivers/gpu/drm/i915/display/intel_display.c
> index fa0abfdff2ae..adb70d76a61c 100644
> --- a/drivers/gpu/drm/i915/display/intel_display.c
> +++ b/drivers/gpu/drm/i915/display/intel_display.c
> @@ -11214,7 +11214,7 @@ int intel_get_load_detect_pipe(struct drm_connector *connector,
>  		goto fail;
>  	}
>  
> -	crtc_state->base.active = crtc_state->base.enable = true;
> +	crtc_state->hw.active = true;

Ugh, should of course be uapi.active, because I split it out. :(

Will fix.


_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx