[PATCH v3 3/5] selftests: ftrace: Add more verbosity for immediate log

[Masami Hiramatsu <mhiramat@kernel.org>]

Add 3-level verbosity for showing traced command log
on console immediately. Since some test cases can cause
kernel pacic if there is a probrem (like regression etc.),
we can not know which command caused the problem without
traced command log. This verbosity (-vvv) solves that
because it shows the log on console immediately. User
can get continuous command/error log.

Note that this is a kind of kernel debug mode, if you
don't see any kernel related issue, you don't need this
verbosity.

Signed-off-by: Masami Hiramatsu <mhiramat@kernel.org>
---
  Changes in v2:
    - Do not show failure log on console again.
---
 tools/testing/selftests/ftrace/ftracetest |   10 +++++++---
 1 file changed, 7 insertions(+), 3 deletions(-)

diff --git a/tools/testing/selftests/ftrace/ftracetest b/tools/testing/selftests/ftrace/ftracetest
index e033f54..892ca4e 100755
--- a/tools/testing/selftests/ftrace/ftracetest
+++ b/tools/testing/selftests/ftrace/ftracetest
@@ -15,6 +15,7 @@ echo "		-h|--help  Show help message"
 echo "		-k|--keep  Keep passed test logs"
 echo "		-v|--verbose Increase verbosity of test messages"
 echo "		-vv        Alias of -v -v (Show all results in stdout)"
+echo "		-vvv       Alias of -v -v -v (Show all commands immediately)"
 echo "		--fail-unsupported Treat UNSUPPORTED as a failure"
 echo "		-d|--debug Debug mode (trace all shell commands)"
 echo "		-l|--logdir <dir> Save logs on the <dir>"
@@ -57,9 +58,10 @@ parse_opts() { # opts
       KEEP_LOG=1
       shift 1
     ;;
-    --verbose|-v|-vv)
+    --verbose|-v|-vv|-vvv)
       VERBOSE=$((VERBOSE + 1))
       [ $1 = '-vv' ] && VERBOSE=$((VERBOSE + 1))
+      [ $1 = '-vvv' ] && VERBOSE=$((VERBOSE + 2))
       shift 1
     ;;
     --debug|-d)
@@ -258,7 +260,9 @@ run_test() { # testfile
   testcase $1
   echo "execute$INSTANCE: "$1 > $testlog
   SIG_RESULT=0
-  if [ $VERBOSE -ge 2 ]; then
+  if [ $VERBOSE -ge 3 ]; then
+    __run_test $1 | tee -a $testlog 2>&1
+  elif [ $VERBOSE -eq 2 ]; then
     __run_test $1 2>> $testlog | tee -a $testlog
   else
     __run_test $1 >> $testlog 2>&1
@@ -268,7 +272,7 @@ run_test() { # testfile
     # Remove test log if the test was done as it was expected.
     [ $KEEP_LOG -eq 0 ] && rm $testlog
   else
-    [ $VERBOSE -ge 1 ] && catlog $testlog
+    [ $VERBOSE -eq 1 -o $VERBOSE -eq 2 ] && catlog $testlog
     TOTAL_RESULT=1
   fi
   rm -rf $TMPDIR