Re: em28xx: msi Digivox ATSC board id [0db0:8810]

[Matthew Gyurgyik <matthew@pyther.net>]

On 12/08/2012 10:20 AM, Frank Schäfer wrote:
> Am 08.12.2012 15:10, schrieb Matthew Gyurgyik:
>
> Ok, thanks. So the USB log was right and the bridge setup should be
> complete, except that the remote control doesn't work yet...
>
> Could you please test the patch in the attachment ?
> Changes from V3:
> - use the correct demodulator configuration
> - changed the remote control map to RC_MAP_KWORLD_315U (same as DIGIVOX
> III but without NEC extended address byte)
> - switched from the KWorld std_map for the tuner to a custom one. For
> QAM, I selected the values from the log and for atsc I took the standard
> values from the tda18271 driver.
>
> Regards,
> Frank
>

I tested the patch and this is what I found

The remote still doesn't work, would it be helpful to do a usb snoop 
while using the remote in windows (not sure I can make the win7 driver 
work in xp)?

http://pyther.net/a/digivox_atsc/patch4/evtest.txt

A channel scan still fails with the following error:
 > start_filter:1752: ERROR: ioctl DMX_SET_FILTER failed: 71 Protocol error

However there are no messages in dmesg that indicate any errors / warnings.
http://pyther.net/a/digivox_atsc/patch4/scan.txt

When using mplayer dvb://

It seems that switching channels work a bit better, I can switch more 
channels before I get errors and mplayer closes.

http://pyther.net/a/digivox_atsc/patch4/mplayer.txt

Dmesg: http://pyther.net/a/digivox_atsc/patch4/dmesg.txt

Thanks,
Matthew