Re: em28xx: msi Digivox ATSC board id [0db0:8810]

[Matthew Gyurgyik <matthew@pyther.net>]

On 12/09/2012 12:06 PM, Frank Schäfer wrote:
> Forget this sh... (never do multiple things at the same time ;) )
>
> Reg 0x50 is set to according to rc_type specified in the selected remote
> control map.
> So if the correct map is selected, everything should be fine (as long as
> it is RC_TYPE_NEC or RC_TYPE_RC5 because we don't support others yet).
>
> RC_MAP_KWORLD_315U and RC_MAP_MSI_DIGIVOX_III are both RC_TYPE_NEC, so
> the stick seems to use no NEC protocol.
>
> Matthew, insert a line
>
>          ir_config = 0x01;
>
> before
>
> 380        em28xx_write_regs(dev, EM2874_R50_IR_CONFIG, &ir_config, 1);
>
> in em28xx-input.c and see if something shows up in the dmesg output.
>
> Regards,
> Frank

That seems to be a bit more successful!

Here is the dmesg output:

> [root@tux ~]# dmesg -t | sort | uniq | grep 'em28xx IR' | grep handle
> em28xx IR (em28xx #0)/ir: 6em28xx_ir_handle_key: toggle: 0, count: 1, key 0x61d6
> em28xx IR (em28xx #0)/ir: 6em28xx_ir_handle_key: toggle: 0, count: 2, key 0x61d6
> em28xx IR (em28xx #0)/ir: 6em28xx_ir_handle_key: toggle: 1, count: 1, key 0x61d6
> em28xx IR (em28xx #0)/ir: em28xx_ir_handle_key: toggle: 0, count: 1, key 0x61d6
> em28xx IR (em28xx #0)/ir: em28xx_ir_handle_key: toggle: 0, count: 2, key 0x61d6
> em28xx IR (em28xx #0)/ir: em28xx_ir_handle_key: toggle: 1, count: 1, key 0x61d6
> em28xx IR (em28xx #0)/ir: em28xx_ir_handle_key: toggle: 1, count: 2, key 0x61d6

I pressed all the buttons on the remote (40 buttons).

Thanks,
Matthew