Re: [PATCH 8/9] iio: imu: st_lsm6dsx: add event configurability on a per axis basis

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Mon, Nov 17, 2025 at 08:23:35PM +0100, Francesco Lavra wrote:
> On Thu, 2025-10-30 at 15:56 +0200, Andy Shevchenko wrote:
> > On Thu, Oct 30, 2025 at 12:23:19PM +0100, Francesco Lavra wrote:
> > > On Thu, 2025-10-30 at 10:24 +0200, Andy Shevchenko wrote:
> > > > On Thu, Oct 30, 2025 at 08:27:51AM +0100, Francesco Lavra wrote:

...

> > > > > +       old_enable = hw->enable_event[event];
> > > > > +       new_enable = state ? (old_enable | BIT(axis)) : (old_enable
> > > > > &
> > > > > ~BIT(axis));
> > > > > +       if (!!old_enable == !!new_enable)
> > > > 
> > > > This is an interesting check. So, old_enable and new_enable are _not_
> > > > booleans, right?
> > > > So, this means the check test if _any_ of the bit was set and kept
> > > > set or
> > > > none were set
> > > > and non is going to be set. Correct? I think a short comment would be
> > > > good to have.
> > > 
> > > old_enable and new_enable are bit masks, but we are only interested in
> > > whether any bit is set, to catch the cases where the bit mask goes from
> > > zero to non-zero and vice versa. Will add a comment.
> > 
> > If it's a true bitmask (assuming unsigned long type) then all this can be
> > done
> > via bitmap API calls. Otherwise you can also compare a Hamming weights of
> > them
> > (probably that gives even the same size of the object file, but !!
> > instructions
> >  will be changed to hweight() calls (still a single assembly instr on
> > modern
> >  architectures).
> 
> These are u8 variables, so we can't use the bitmap API.

OK. But hweight8() can still be used.

> And I don't
> understand the reason for using hweight(), given that the !! operators
> would still be needed.

No, you won't need !! with that.

-- 
With Best Regards,
Andy Shevchenko