[PATCH 22/34] arm64: dts: qcom: qcs404: Move PCIe phy and GPIOs to root port node

[Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>]

The PCIe phy reference and the perst GPIO property are per root port
and belong in the root port node (pcie@0), not in the RC controller
node. Move phys and phy-names from the controller to pcie0_port0,
adding a label to this node to allow board-level overrides. Move
perst-gpios from the &pcie controller override to &pcie0_port0 in
the board file, renaming perst-gpios to reset-gpios to match the
binding used in the root port context.

Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>
---
 arch/arm64/boot/dts/qcom/qcs404-evb.dtsi | 6 ++++--
 arch/arm64/boot/dts/qcom/qcs404.dtsi     | 7 +++----
 2 files changed, 7 insertions(+), 6 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/qcs404-evb.dtsi b/arch/arm64/boot/dts/qcom/qcs404-evb.dtsi
index a22b4501ce1e..a035546a1b97 100644
--- a/arch/arm64/boot/dts/qcom/qcs404-evb.dtsi
+++ b/arch/arm64/boot/dts/qcom/qcs404-evb.dtsi
@@ -101,12 +101,14 @@ pms405_s3: s3 {
 &pcie {
 	status = "okay";
 
-	perst-gpios = <&tlmm 43 GPIO_ACTIVE_LOW>;
-
 	pinctrl-names = "default";
 	pinctrl-0 = <&perst_state>;
 };
 
+&pcie0_port0 {
+	reset-gpios = <&tlmm 43 GPIO_ACTIVE_LOW>;
+};
+
 &pcie_phy {
 	status = "okay";
 
diff --git a/arch/arm64/boot/dts/qcom/qcs404.dtsi b/arch/arm64/boot/dts/qcom/qcs404.dtsi
index 736accfc34f9..b661505b409d 100644
--- a/arch/arm64/boot/dts/qcom/qcs404.dtsi
+++ b/arch/arm64/boot/dts/qcom/qcs404.dtsi
@@ -1517,16 +1517,15 @@ pcie: pcie@10000000 {
 				      "pwr",
 				      "ahb";
 
-			phys = <&pcie_phy>;
-			phy-names = "pciephy";
-
 			status = "disabled";
 
-			pcie@0 {
+			pcie0_port0: pcie@0 {
 				device_type = "pci";
 				reg = <0x0 0x0 0x0 0x0 0x0>;
 				bus-range = <0x01 0xff>;
 
+				phys = <&pcie_phy>;
+
 				#address-cells = <3>;
 				#size-cells = <2>;
 				ranges;

-- 
2.34.1